Kickstand, Carpet Dryer X8874

$7.99

Genuine OEM wire kickstand for commercial carpet dryers and air movers — the formed steel stand that sets and holds the machine’s operating angle. Fits Tornado and Powr-Flite models (see the full list below).

The kickstand is the formed steel wire stand that props the dryer at its working angle. On a centrifugal dryer that angle is the difference between laying a sheet of air along the carpet and blowing it into the middle of the room, so the kickstand is a performance part as much as a convenience. It pivots in bosses moulded into the housing halves and carries the soft feet at its contact points.

Compatible Models

  • Tornado: 98774 Windshear 3200, 98776, 98780
  • Powr-Flite: PDS1 Powr-Dryer, PD350 Powr-Dryer, PD500 Powr-Dryer, PDH2 Deluxe Hybrid 3-Speed Carpet Dryer
  • and other Tornado and Powr-Flite air-mover and dryer models — call 763-535-0770 to confirm

What goes wrong is mechanical and visible. The wire bends when a machine is dropped or stacked badly, and a bent stand puts the dryer at the wrong angle or lets it rock on three points instead of sitting square. The pivot ends wear or spread so the stand flops rather than staying where it is set. And on machines stored damp, the stand rusts at the feet where moisture sits.

Fit the soft feet (part# X1375 left, part# X1376 right) when you change a kickstand, because old flattened feet on a new stand reproduce the original symptom. If the stand is sound but the machine still will not sit square, inspect the pivot bosses on the housing halves — running a machine with a missing foot loads those bosses directly and cracks them, and at that point the housing (part# X1370 or part# X1371) is what needs replacing, not the stand.

Frequently Asked Questions

What does the kickstand do on a commercial carpet dryer?

The kickstand (part# X8874) is the formed steel wire stand that props the dryer at its working angle. That angle determines whether the machine lays its airflow along the carpet or into the room, and the stand pivots in bosses moulded into the housing halves.

How do I know if my kickstand needs replacing?

Replace it if the wire is bent so the machine sits at the wrong angle or rocks instead of sitting square, if the pivot ends have worn or spread so the stand will not stay where it is set, or if it has rusted badly at the feet. Fit new soft feet (part# X1375 and part# X1376) at the same time, since worn feet on a new stand reproduce the same symptom.

What models is the kickstand, Carpet Dryer (part# X8874) compatible with?

It fits Tornado 98774 Windshear 3200, 98776, 98780; Powr-Flite PDS1 Powr-Dryer, PD350 Powr-Dryer, PD500 Powr-Dryer, PDH2 Deluxe Hybrid 3-Speed Carpet Dryer, and other Tornado and Powr-Flite air-mover and dryer models — call 763-535-0770 to confirm. Compatibility is listed in full in the Compatible Models section on this page.

How do I order the kickstand, Carpet Dryer (part# X8874) or get help?

You can add the Kickstand, Carpet Dryer (part# X8874) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Need help identifying the right part? Call Twin City Vacuum at 763-535-0770.

Reviews

There are no reviews yet

Be the first to review “Kickstand, Carpet Dryer X8874”

Your email address will not be published. Required fields are marked *