Tornado Intake Panel X8872A
$78.99
Genuine OEM Tornado intake panel (part# X8872A) — the round louvered inlet guard on the Windshear SD3500 air mover, Model 98776.
Genuine OEM Tornado intake panel (part# X8872A) for the Windshear SD3500 axial air mover. This is the round, louvered guard that covers the air inlet on the back of the machine. Every cubic foot of air the dryer moves passes through it, and it is the only thing standing between a spinning fan wheel and whatever is lying on the floor beside the machine.
The panel is a moulded plastic disc with radial ribs and a dense pattern of slots sized to pass air freely while blocking fingers, carpet fibre, cord ends and debris. Tornado lists this part as the intake panel rather than the inlet grill. It is the current version, and it is the one to order whichever style your machine was built with.
When to replace it: an air mover lives a hard life. It gets stood on end, thrown into a van, dragged across thresholds and knocked over on wet floors, and the intake panel is almost always the first thing to take the hit. Replace it if any of the ribs are cracked or missing, if a section of the louvre pattern has broken out and left an opening a finger could reach through, if the panel no longer clips or screws down flat, or if it has warped enough to rub the fan. A damaged inlet guard is a genuine safety item, not a cosmetic one — an exposed axial fan at full speed will take a finger.
Performance matters too. A panel packed with lint and pet hair chokes airflow, and a choked inlet makes the motor work harder, run hotter and dry more slowly. Pull the panel at every service, wash it in warm water, let it dry fully and refit it. If it has gone brittle with age and UV, replace it rather than keep cleaning it.
Fitting is straightforward: remove the retaining screws, lift the old panel clear, seat the new one squarely and snug the screws into their plastic bosses without over-tightening. If you are also replacing the discharge grill at the other end of the airflow path, do both while the machine is open.
Compatible Models
- Tornado Windshear SD3500 Model 98776 (and the 98777 230V export version)
- and other Tornado Windshear SD3500 series air movers — call 763-535-0770 to confirm
Frequently Asked Questions
What does the Tornado intake panel (part# X8872A) do on the Windshear SD3500?
It is the louvered inlet guard on the air-intake side of the machine. It keeps fingers, cord ends, carpet fibre and floor debris out of the spinning axial fan while letting the dryer pull its full volume of air.
How do I know if my Tornado intake panel (part# X8872A) needs replacing?
Inspect it for cracked or missing ribs, a broken-out section of the louvre pattern, warping that lets it rub the fan, or mounting bosses that will no longer hold it flat. Any opening large enough to admit a finger means the panel must be replaced before the machine is used again.
Is the intake panel the same thing as the inlet grill?
Yes. Tornado lists this part as the intake panel rather than the inlet grill, and it is the current version. If your machine was built with the older style, this is still the part to order.
What models is the Tornado intake panel (part# X8872A) compatible with?
It fits the Tornado Windshear SD3500 Model 98776 and the 98777 230V export version of the same machine. Call 763-535-0770 with your model and serial number and we will confirm it against your machine.
How do I order the Tornado intake panel (part# X8872A) or get help?
You can add the Tornado intake panel (part# X8872A) directly to your cart on this page, or call us at 763-535-0770.
You can add this part directly to your cart on this page, or call us at 763-535-0770.






Reviews
There are no reviews yet