CleanMax ZM-800 DC Handle and PCB Wire Harness B223-6000
$12.99
Genuine CleanMax ZM-800 DC handle/PCB wire harness (part# B223-6000) for the commercial ZM-800. Carries control signals and DC power. Call 763-535-0770.
The ZM-800 DC Handle and PCB Wire Harness (part# B223-6000) is the wiring harness that connects the handle controls and the printed circuit board (PCB) on the commercial CleanMax ZM-800 battery upright. It is the nervous system that carries the operator’s switch inputs and low-voltage DC power between the handle and the machine’s control electronics.
Compatible Models for the ZM-800 DC Handle and PCB Wire Harness
This is a genuine Tacony OEM part for the CleanMax ZM-800 commercial battery upright. It is used on the commercial ZM-800 configuration. If you are unsure which CleanMax model or serial range you have, call 763-535-0770 and we will confirm the correct part before you order.
What the ZM-800 DC Handle and PCB Wire Harness does
This harness routes the DC power and control signals from the handle-mounted switch to the PCB that manages the ZM-800’s motor and battery system. Every time the operator turns the machine on or changes a setting, that signal travels through this harness. On a cordless commercial machine the control electronics depend on clean, uninterrupted connections, so a genuine harness with the correct connectors and gauge is what keeps the on/off and control functions reliable. Because it flexes with the handle and carries current, it is a wear and failure point over the machine’s life.
Signs the ZM-800 DC Handle and PCB Wire Harness needs replacing
Replace the harness if the machine responds intermittently to the switch, if it will not power on or off reliably, or if you find chafed, pinched, or heat-discolored wires or loose and corroded connectors when the handle is opened. A harness with a broken conductor often shows up as controls that work only when the handle is held at a certain angle — a sign the wire is broken inside the insulation and the harness should be replaced.
Installation and fit
Power down and isolate the battery before opening the handle or body. Photograph the connector positions, unplug the old harness at the handle and PCB, route the new harness exactly as the original with the same clips and strain relief, and reconnect it so no wire is pinched. Twin City Vacuum has sold and serviced CleanMax equipment since 1956, and every part is sourced directly from Tacony. Browse more CleanMax parts, or learn more at CleanMax.
Frequently Asked Questions
What does the DC Handle and PCB Wire Harness do on the CleanMax ZM-800?
It carries the DC power and control signals between the handle switch and the PCB that manages the commercial ZM-800’s motor and battery system, so the operator’s inputs reach the control board.
How do I know if my ZM-800 DC Handle and PCB Wire Harness needs replacing?
Replace it if the machine responds intermittently or will not power on and off reliably, or if you find chafed, pinched, or heat-discolored wires or loose, corroded connectors in the handle or body.
What models is the DC Handle and PCB Wire Harness (part# B223-6000) compatible with?
It is the genuine handle/PCB harness for the commercial CleanMax ZM-800. Call 763-535-0770 to confirm fit and configuration for your exact ZM-800.
How do I order the DC Handle and PCB Wire Harness (part# B223-6000) or get help?
You can add the DC Handle and PCB Wire Harness (part# B223-6000) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing CleanMax equipment since 1956 and can help confirm the right part for your machine.
Questions? Call us at 763-535-0770 or visit 5415 West Broadway, Crystal, MN 55428.
