Bent Fitting 62320050
$8.99
Genuine OEM bent fitting (part# 62320050) for Tornado floor scrubbers. It is the elbow that turns the solution line at the water valve.
Genuine OEM bent fitting (part# 62320050) for Tornado floor scrubbers — compatible machines are listed below. In the water valve assembly it is the elbow that turns a solution line through an angle in the tight space around the valve.
Around a valve there is rarely room for a hose to make a graceful curve, and that is why the elbow exists. A hose forced around a tight radius kinks, and a kink is a restriction nobody can see: it cuts flow at every control setting and eventually cracks the hose where it is folded. The fitting makes the turn with a known internal radius, so the pressure drop is designed in rather than accidental.
Which is also why swapping in a different elbow is a bad idea even when the threads match. A tighter internal bend or a smaller bore changes the restriction, and the machine then lays down less solution with nothing visibly wrong to point at.
Elbows fail where the bend concentrates stress — at the outside of the turn, and at the thread root. The usual cause is leverage: a hose being pulled off, or the fitting being used as a handhold while something else is undone. Plastic also grows brittle with age and chemical exposure, so a fitting that has been in service for years can break the next time a hose is removed.
These cracks typically weep only under flow, and on the solution side that means air drawn into the line and flow that varies run to run. Inspect along the outside of the bend and at the thread root whenever this plumbing is opened, check the barb ridges are still sharp, and replace any fitting that has been over-tightened.
Compatible Models
- Tornado BD 28/20 — 99728
- Tornado BD 32/26 — 99732
- Tornado BD 33/30 — 99780
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BDSO 20/21 — TS120-S59-U
- Tornado TS530-W26-U
- Tornado TS530-W30-U
This part is shared across 7 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the water valve drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the bent fitting (part# 62320050) do?
It turns a solution line through an angle in the tight space around the water valve, with a known internal radius, where forcing the hose round the corner would kink it.
Can I substitute another elbow with the same thread?
Better not to. A tighter internal bend or a smaller bore changes the restriction, and the machine then lays down less solution at every setting with nothing visibly wrong to point at.
Where do these crack?
At the outside of the bend and at the thread root, where the turn concentrates stress — usually from leverage when a hose is pulled off or the fitting is used as a handhold. The crack typically weeps only under flow, drawing air into the line.
How do I order the Bent Fitting (part# 62320050) or get help?
You can add the Bent Fitting (part# 62320050) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the bent fitting (part# 62320050) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet