Tornado BDSO 27/28 Parts Diagrams

Every Tornado BDSO 27/28 parts diagram in one place. The BDSO 27/28 is a stand-on scrubber sold as Models 99786 and 99786C. Pick the assembly you need below — each page shows Tornado’s drawing with every numbered item listed underneath it. Can’t find your part? Call us at 763-535-0770.

Open a card to see that assembly’s drawing and parts list. Where Tornado revised an assembly during production, every revision appears on the same page in serial order, oldest first, with the serial range stated above each drawing — so check the serial number on your machine’s data plate before you order.

Tornado BDSO 27/28 Parts for Models 99786 and 99786C

These 23 assemblies cover the whole machine: the brush base and its control and transmission, the squeegee and squeegee control, the recovery and solution tanks, the water valve and water filter, the vacuum and suction path, the drive wheel control, the steering wheel, the frame, the foot board, the lower and rear covers, the rear wheel, the battery charger, and the block, electrical layout and detailed wiring reference drawings. Between them Tornado publishes 49 drawings for this machine, because several assemblies were revised during a long production run.

That is the thing to know before ordering Tornado BDSO 27/28 parts: the serial number matters as much as the model number. The brush base, control panel, squeegee control, steering wheel, drive wheel control, vacuum, recovery tank, solution tank, frame, battery charger, electrical layout and wiring all have more than one drawing, each covering a different block of serial numbers. Parts are not always interchangeable across those breaks. Every page here lists each revision separately with its range printed above the drawing, so you can match your machine instead of guessing.

On a stand-on scrubber the parts that move fastest are the ones touching the floor and the water — squeegee blades, brushes and pad drivers, the recovery tank lid gasket, the vacuum motor and its mounting gasket, the water filter screen and the water valve. Drive and steering parts wear slowly but take a machine out of service when they let go. Electrical faults usually come back to a switch, relay, contactor or harness on one of the three reference drawings rather than to the controller itself.

Twin City Vacuum has sold and serviced commercial floor equipment from 5415 West Broadway in Crystal, Minnesota since 1956. If you are not certain which assembly your part belongs to, call 763-535-0770 — describing the symptom usually gets there faster than reading drawings. You can also browse the Tornado BDSO 27/28 parts category, the full Tornado cleaning equipment parts catalog, or Tornado’s own machine information at tornadovac.com.

Frequently Asked Questions About Tornado BDSO 27/28 Parts

How many parts diagrams does the Tornado BDSO 27/28 have?

Twenty-three assemblies, covered by 49 drawings in total. Several assemblies were revised during production, so an assembly can have anywhere from one to six drawings. All of an assembly’s revisions are on the same page here, in serial order.

Why does one assembly have several drawings?

Because Tornado changed the assembly at a particular serial number. The electrical layout has six versions, the detailed wiring diagram and squeegee control have four each, and the control panel, drive wheel control, steering wheel and vacuum have three. The serial range is printed above every drawing.

Where do I find the serial number on my BDSO 27/28?

On the machine’s data plate. If the plate is damaged or missing, call 763-535-0770 — we can usually place a machine from its build details and the parts already on it.

How do I order Tornado BDSO 27/28 parts, or get help identifying one?

Open the assembly page, find your item number on the drawing and order the matching row, or call 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has serviced commercial floor equipment since 1956 and can confirm the right part for your serial number.