Find genuine Tornado BDSO 27/28 replacement parts for Models 99786 and 99786C. Can’t find your part? Call us at 763-535-0770.
Find the item number on the drawing, then match it to the same number in the table below that drawing. Each table lists the part description and Tornado’s part number for every numbered item on that sheet.
Foot Board Drawing
Tornado publishes one drawing for this assembly, covering every BDSO 27/28 serial number.
1. Bushing – 4711502010. Washer – 6030300211. Pedal Support – 2151304012. Microswitch – 6340900913. Screw M3 x 20 – 6014030614. Spring Clip – 6212060414. Spring Clip – 6212060415. Pin – 2151302016. Screw M6 x 16 INOX – 6018060317. Screw M3 x 20 – 6014030618. Microswitch – 6340900919. Washer – 603030022. Conical Washer – 6051400120. Lock Nut – 6022030221. Rubber Washer – 2151108022. Washer – 6030600823. Screw M6 x 30 INOX – 6011061824. Spring – 4721028025. Bushing – 4711503026. Washer INOX – 6030601127. Washer – 6030600528. Lock Washer INOX – 6050600729. Screw M6 x 20 INOX – 601106113. Foot Board – 2151104030. Eye Support – 6371400231. Screw M3.9 x 14 – 601903104. Washer INOX – 603080075. Lock Washer INOX – 605080066. Screw M8 x 20 – 601108067. Pedal – 215130108. Spring – 472102909. Lock Nut – 60220302The foot board is the operator platform on the BDSO 27/28 — the deck the operator stands on, its mat or tread surface, the mounting hardware, and the presence switch that tells the machine someone is aboard. It is a safety assembly as much as a structural one. A worn mat is a slip hazard on a wet floor, and a failed presence switch will either stop the machine from driving at all or, worse, let it drive with nobody on it. If your scrubber will not move but everything else works, the presence switch on this drawing is the first thing to check.
Frequently Asked Questions About the Tornado BDSO 27/28 Foot Board
My BDSO 27/28 will not drive even though it powers up. Could it be the foot board?
Yes. The operator presence switch on this drawing has to close before the machine will drive. If it has failed or come out of adjustment, the machine powers up normally and simply will not move.
Is the foot board mat a wear item?
It is. The tread surface wears smooth, and on a machine that works wet floors a smooth platform is a slip hazard. Replace it when the texture is gone, not when it tears.
Is the foot board the same across all serial numbers?
Yes. Tornado publishes a single foot board drawing for the BDSO 27/28, so there is no serial-number question on this assembly.
Not sure which foot board part your machine takes? Call 763-535-0770 with the serial number from the data plate, or stop in at 5415 West Broadway, Crystal, MN 55428 — we have sold and serviced commercial floor equipment since 1956. You can also go back to all Tornado BDSO 27/28 parts diagrams or browse the Tornado BDSO 27/28 parts category.

























