Microswitch 63409009
$54.99
Genuine OEM microswitch (part# 63409009) for Tornado floor scrubbers. It is the snap-action switch the safety pedal presses to tell the controller an operator is aboard.
Genuine OEM microswitch (part# 63409009) for Tornado floor scrubbers — compatible machines are listed below. On the foot board assembly it is the switch the safety pedal operates, and it appears at squeegee positions on the same machines, so one part number covers several of the machine’s position-sensing jobs.
A microswitch is a snap-action device: a small, precise amount of plunger travel flips the contacts over centre with a click, and the same small travel flips them back. That precision is the point — the controller needs an unambiguous signal, not a contact that drifts closed as something slowly moves. It is also why the switch is so sensitive to the mechanical parts around it. A worn pedal pivot, a tired return spring or a bent bracket changes where the plunger sits, and the switch gets blamed for a fault that is not electrical at all.
Genuine failures do happen. Contacts can weld or go high-resistance after enough cycles; the plunger can stick, usually from dried cleaning solution or grit around the body; moisture can get inside and corrode the terminals; and the body or lever can crack from a knock. Symptoms are a machine that will not enable with an operator aboard, one that stays enabled after dismount, or behaviour that comes and goes as the machine vibrates.
Before replacing, test it off the machine: you should feel and hear a clean click, and continuity should change state at exactly that click with no vagueness either side. Then check what operates it — the pedal, its pin, its support and its spring — because a switch replaced into a worn mechanism fails the same way again.
This is the genuine Tornado switch with the correct rating, travel and terminal arrangement.
Compatible Models
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BDSO 20/21 — TS120-S59-U
This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the foot board drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the microswitch (part# 63409009) do on a Tornado scrubber?
It is the snap-action switch the safety pedal presses to tell the controller an operator is aboard. The same part number is also used at squeegee positions on these machines.
My presence detection is intermittent. Is the switch at fault?
Not necessarily. The switch needs a precise amount of plunger travel, so a worn pedal pivot, a tired return spring or a bent support changes where the plunger sits and produces exactly these symptoms. Check the mechanism before condemning the switch.
How do I test the microswitch (part# 63409009)?
Off the machine, you should feel and hear a clean click, and continuity should change state at exactly that click with no vagueness either side. A sticky plunger, usually from dried cleaning solution or grit, and corroded terminals from moisture ingress are the common genuine failures.
How do I order the Microswitch (part# 63409009) or get help?
You can add the Microswitch (part# 63409009) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the microswitch (part# 63409009) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet