Squeegee Bushing 47115020
$13.99
Genuine OEM squeegee bushing (part# 47115020) for Tornado floor scrubbers. It is the sleeve bearing at the squeegee pivot that keeps the assembly swinging true instead of rattling.
Genuine OEM squeegee bushing (part# 47115020) for Tornado floor scrubbers — compatible machines are listed below. It is the sleeve that lines a pivot point on the squeegee linkage, letting the assembly rotate smoothly on its pin while keeping the joint tight.
The squeegee is on a pivot for a reason: it has to follow the floor, swing out of the way when it catches something, and trail true behind the machine while it is being dragged through standing water. A bushing is what makes that pivot a bearing rather than a hole. It takes the wear instead of the much more expensive linkage, and it keeps the joint concentric so the squeegee sits square to the floor.
When it wears the symptoms are on the floor, not in the joint. The squeegee starts leaving streaks on one side as the blade stops meeting the floor evenly, or you get a line of water left behind on turns because the assembly is free to cock slightly as it swings. Chatter or a knocking sound from the squeegee over rough floor points the same way.
Inspect it with the pin out: an unworn bushing is round and a snug sliding fit on the pin; a worn one is oval, thin on the loaded side, or split. Replace the bushings in a joint as a set and check the pin too — a scored or stepped pin will chew a new bushing out quickly. Do not fit a bushing dry if the service procedure calls for lubrication.
This is the genuine Tornado bushing in the correct bore, length and material, so the pivot has the clearance it was designed around and the squeegee tracks straight.
Compatible Models
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BDSO 20/21 — TS120-S59-U
This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the foot board drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the squeegee bushing (part# 47115020) do?
It lines a pivot point on the squeegee linkage so the assembly rotates smoothly on its pin. The bushing takes the wear instead of the linkage, and keeps the joint concentric so the squeegee sits square to the floor.
My squeegee is streaking on one side. Could this be the cause?
It can be. A worn bushing lets the assembly cock slightly, so the blade stops meeting the floor evenly and leaves streaks or a line of water on turns. Chatter or knocking from the squeegee over rough floor points the same way.
How do I check whether the bushing is worn?
Take the pin out and look. A good bushing is round and a snug sliding fit on the pin; a worn one is oval, thin on the loaded side, or split. Check the pin as well — a scored or stepped pin will chew a new bushing out quickly.
How do I order the Squeegee Bushing (part# 47115020) or get help?
You can add the Squeegee Bushing (part# 47115020) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the squeegee bushing (part# 47115020) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet