Front Cover Bushing 47115030

$13.99

Genuine OEM front cover bushing (part# 47115030) for Tornado floor scrubbers. It is the sleeve at the front cover’s hinge point that lets the cover swing without wearing its own mounting holes.

Genuine OEM front cover bushing (part# 47115030) for Tornado floor scrubbers — the machines it fits are listed below. It lines the front cover’s hinge point so the cover pivots on a bearing surface instead of directly on a bolt through a hole.

The front cover gets opened constantly — for brush changes, for pad changes, to look at anything under it — and every one of those cycles loads the hinge. Without a bushing the fastener slowly reams out the cover’s hole, and once that hole is oval the cover no longer closes in the same place: it sits proud on one side, the latch stops lining up, and the gap it is meant to seal becomes a path for spray.

So the bushing is the sacrificial part. It is far cheaper than a cover, and replacing it on schedule is what stops a cover that is still perfectly good from becoming scrap. Inspect it whenever the cover starts to feel loose, drops a little when you let go of it, or needs lifting to get the latch to catch.

Look for the usual wear signs with the hinge pin or bolt removed: ovality, a thin spot on the loaded side, splits, or a bushing that has started to spin in its bore instead of the pin turning in the bushing. Replace in pairs where the hinge uses two, and check that the fastener is not scored — a rough pin shortens the new bushing’s life considerably.

This is the genuine Tornado bushing in the correct bore, outside diameter and length, so the cover hangs at the right height and the latch lines up the way it did when the machine was new.

Compatible Models

This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the foot board drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the front cover bushing (part# 47115030) do?

It lines the front cover’s hinge so the cover pivots on a bearing surface rather than directly on a bolt through a hole. It takes the wear that would otherwise ream out the cover itself.

The front cover sits crooked and the latch will not line up. Why?

That is the classic worn-hinge symptom. Once the bushing is gone the fastener wears the cover’s hole oval, the cover stops closing in the same place, and the gap it is meant to seal becomes a path for spray.

How often should I replace it?

Inspect it whenever the cover feels loose, drops slightly when you let go, or needs lifting for the latch to catch. Replacing a worn bushing on schedule is what stops a perfectly good cover from becoming scrap.

How do I order the Front Cover Bushing (part# 47115030) or get help?

You can add the Front Cover Bushing (part# 47115030) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the front cover bushing (part# 47115030) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Front Cover Bushing 47115030”

Your email address will not be published. Required fields are marked *