Screw M3 x 20 60140306

$1.99

Genuine OEM M3 x 20 mm screw (part# 60140306) for Tornado floor scrubbers. It is the small fastener that holds switches and light electrical components to their brackets.

Genuine OEM M3 x 20 mm screw (part# 60140306) for Tornado floor scrubbers — compatible machines are listed below. On the foot board assembly it appears at the positions where a switch or a small electrical component mounts to its bracket.

M3 is the smallest thread on the machine and it is used where precision matters more than clamping force. A microswitch, for instance, has to sit at an exact distance from whatever operates it; the screws that hold it are not carrying load so much as holding a position. That changes how they should be treated. There is very little thread engaged and very little head to grip, so an M3 strips easily, and the usual damage is a rounded drive recess from someone reaching for a driver that was almost the right size.

The length matters for the same reason. M3 x 20 is long for its diameter because it passes through a component body or a spacer before it reaches thread. Substituting a shorter screw leaves the component only partly captured; substituting a longer one can press into the component behind it or foul a moving part.

Replace it whenever the drive recess is damaged, the thread is bent — easy on a screw this slender, and a bent M3 will not pull a switch down square — or it no longer holds. If it no longer holds, check the thread it goes into before fitting a new screw: on M3 the host thread usually fails before the screw does, and a stripped boss needs attention of its own.

This is the genuine Tornado part in the correct size, so switches and components sit where the machine expects them.

Compatible Models

This part is shared across 8 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the foot board drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

Where is the screw (part# 60140306) used on a Tornado scrubber?

At the positions where a switch or small electrical component mounts to its bracket. M3 is used where holding an exact position matters more than clamping force.

Why is it so long for an M3?

Because it passes through a component body or a spacer before it reaches thread. A shorter screw leaves the component only partly captured, and a longer one can press into whatever is behind it or foul a moving part.

The screw will not tighten any more. What should I check?

The thread it goes into. On M3 the host thread usually fails before the screw does, so inspect the boss or tapped hole before fitting a new screw. Also check the screw itself for a bend — M3 is slender enough to bend easily, and a bent one will not pull a switch down square.

How do I order the Screw M3 x 20 (part# 60140306) or get help?

You can add the Screw M3 x 20 (part# 60140306) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m3 x 20 (part# 60140306) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Screw M3 x 20 60140306”

Your email address will not be published. Required fields are marked *