Find genuine Tornado BDSO 27/28 replacement parts for Models 99786 and 99786C. Can’t find your part? Call us at 763-535-0770.
Find the item number on the drawing, then match it to the same number in the table below that drawing. Each table lists the part description and Tornado’s part number for every numbered item on that sheet.
Brush Base Transmission Drawing
Tornado publishes one drawing for this assembly, covering every BDSO 27/28 serial number.
1. Brush Motor – 4620046010. Bushing – 4710301011. Flexible Coupling – 2030205012. Bushing – 4710302013. Lock Washer INOX – 6050800614. Screw M8 x 30 INOX – 6011081015. Lock Nut INOX – 6022060216. Washer INOX – 6030601117. Spring – 4723010018. Screw M6 x 14 INOX – 6011060619. Plastic Brush Holder Plate – 203022502. Washer INOX – 6030500620. Conical Washer – 6050800421. Screw M8 x 25 INOX – 6011080822. Brush Motor Carbon Brushes – 636071423. Lock Washer – 605050034. Screw M5 x 16 INOX – 601105075. Spacer – 470100106. Brush Plate Flange – 210020107. Washer INOX – 603080078. Lock Washer INOX – 605080069. Screw M8 x 14 INOX – 60130802The brush base transmission is the gear train that turns brush motor output into brush rotation on the BDSO 27/28. It is a low-attention assembly — most machines go years without touching it — but when it does fail it fails loudly: a grinding or whining noise that rises with brush speed, or a brush that will not turn while its motor clearly runs. Seals and bearings are the usual wear items, and a transmission that has lost lubricant will take its bearings with it. Tornado publishes a single drawing for this assembly across all BDSO 27/28 serial numbers.
Frequently Asked Questions About the Tornado BDSO 27/28 Brush Base Transmission
My brush motor runs but the brush does not turn. What failed?
Something in the drive path between them — typically a transmission gear, a coupling or a shaft on this drawing. Stop using the machine until it is repaired; running a motor against a seized transmission damages the motor too.
Does this assembly need routine service?
It is not a scheduled service item on this machine, but it is worth listening to. Any new noise that tracks brush speed is a reason to look at the transmission before it takes out a bearing.
Is the transmission the same for all BDSO 27/28 serial numbers?
Yes. Tornado publishes one drawing for the brush base transmission covering the whole production run, so there is no serial-number question on this assembly.
Not sure which brush base transmission part your machine takes? Call 763-535-0770 with the serial number from the data plate, or stop in at 5415 West Broadway, Crystal, MN 55428 — we have sold and serviced commercial floor equipment since 1956. You can also go back to all Tornado BDSO 27/28 parts diagrams or browse the Tornado BDSO 27/28 parts category.




















