Tornado BDSO 27/28 Rear Wheel Parts

Find genuine Tornado BDSO 27/28 replacement parts for Models 99786 and 99786C. Can’t find your part? Call us at 763-535-0770.

Find the item number on the drawing, then match it to the same number in the table below that drawing. Each table lists the part description and Tornado’s part number for every numbered item on that sheet.

Rear Wheel Drawing

Tornado publishes one drawing for this assembly, covering every BDSO 27/28 serial number.

The rear wheel assembly on the BDSO 27/28 is the trailing wheel, its axle, bearings and the hardware that mounts it to the frame. Nine callouts cover the whole assembly. Rear wheels pick up string, shrink wrap and tape, which winds into the bearing and destroys it quietly — the first symptom is usually a wheel that no longer rolls freely rather than a noise. A seized or flat-spotted rear wheel drags, scuffs floors and makes the machine track badly. Tornado publishes a single rear wheel drawing covering every BDSO 27/28 serial number.

#ImagePart DescriptionPart NumberPrice
1Tornado BDSO 27/28 Lock Nut schematic diagram part number 60220803Lock Nut60220803$1.99
2Tornado BDSO 27/28 Washer schematic diagram part number 60308003Washer60308003$1.99
3Tornado BDSO 27/28 Screw M8 x 25 INOX schematic diagram part number 60110808Screw M8 x 25 INOX60110808$1.99
4Tornado BDSO 27/28 Axle Shaft schematic diagram part number 46715010Axle Shaft46715010$122.99
5Tornado BDSO 27/28 Wheel Ring schematic diagram part number 21507010Wheel Ring21507010$15.99
6Tornado BDSO 27/28 Rear Wheel w/ Bearing, (99786) schematic diagram part number V1507001Rear Wheel w/ Bearing, (99786)V1507001$225.99
7Tornado BDSO 27/28 Washer INOX schematic diagram part number 60308010Washer INOX60308010$1.99
8Tornado BDSO 27/28 Lock Washer INOX schematic diagram part number 60508006Lock Washer INOX60508006$1.99
9Tornado BDSO 27/28 Screw M8 x 20 schematic diagram part number 60110806Screw M8 x 2060110806$1.99

Frequently Asked Questions About the Tornado BDSO 27/28 Rear Wheel

My machine has started to track to one side. Could it be the rear wheel?

It can be. A rear wheel with a failing bearing or a flat spot drags, and the machine pulls away from it. Lift the wheel off the floor and spin it by hand; it should turn freely and quietly.

How often do rear wheel bearings need replacing?

There is no fixed interval. What kills them is debris wound around the axle, so the real answer is to clear the wheel when you clean the machine and the bearings will last.

Is the rear wheel different on later BDSO 27/28 machines?

No. One drawing covers the whole production run.

Not sure which rear wheel part your machine takes? Call 763-535-0770 with the serial number from the data plate, or stop in at 5415 West Broadway, Crystal, MN 55428 — we have sold and serviced commercial floor equipment since 1956. You can also go back to all Tornado BDSO 27/28 parts diagrams or browse the Tornado BDSO 27/28 parts category.