Fuse 100A 62810001
$18.99
Genuine OEM 100 amp fuse (part# 62810001) for the Tornado BDSO 27/28. It is the main protection between the battery pack and the machine.
Genuine OEM 100 amp fuse (part# 62810001) for Tornado floor scrubbers — compatible machines are listed below. It sits in the main battery circuit, between the pack and everything the machine runs.
This is the last line of defence, and it should essentially never operate in normal service. Every other fuse on the machine is chosen to blow first, so if the main fuse has gone, something has gone badly wrong downstream and simply fitting another one is the wrong response.
What actually blows a main fuse is a short at battery-current levels: a main cable chafed through to the frame, a contactor whose contacts have welded and then failed, a motor with a shorted winding, or a tool left across the terminals during service. All of those will do it again to the next fuse, and a short at this current level generates enough heat to melt insulation and start a fire — which matters more than usual in a compartment that can contain hydrogen while a lead-acid pack is charging.
So treat a blown main fuse as a fault to find. Disconnect the battery pack before working. Inspect the full length of the main cables, especially where they pass frame edges and where they have been clipped; check the contactor; and check each major motor for a winding short before restoring power.
Check the holder and terminals too: at 100 amps a loose terminal is its own hazard, and a hot joint can open a healthy fuse. Terminals here should be clean, bright and properly tightened.
Compatible Models
- Tornado BD 32/26 — 99732
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the 100 amp fuse (part# 62810001) do?
It is the main protection between the battery pack and the machine — the last line of defence, with every other fuse on the machine chosen to blow before it.
My main fuse blew. Can I just replace it?
No. If the main fuse has gone, something downstream has gone badly wrong: a chafed main cable, a welded contactor, a shorted motor winding, or a tool left across the terminals. The same fault will take the next fuse, and a short at this current can melt insulation and start a fire.
What should I check before restoring power?
Disconnect the pack first. Then inspect the full length of the main cables, especially at frame edges and clip points, check the contactor, and check each major motor for a winding short. Make sure the holder terminals are clean, bright and properly tightened.
How do I order the Fuse 100A (part# 62810001) or get help?
You can add the Fuse 100A (part# 62810001) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the fuse 100a (part# 62810001) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet