Tornado Motor Mount Washer X9374

$2.99

Genuine OEM washer (part# X9374) for commercial high-speed burnishers — the washer listed with the motor and motor pulley hardware on the Tornado Brute Force 2000 (98482B) and 2000 Dust Control (98486).

SKU: X9374 Category: Brand:

The X9374 is a washer listed at on the Brute Force 2000 (98482B) drawing and on both Brute Force 2000 Dust Control (98486) drawings, immediately after the O-groove motor pulley (X9298) and just before the split lock washer (01577) and the 5/16 x 3/4 inch screw (X9327). It is not listed on the Brute Force 1600 (98458B) drawing, which uses a different motor pulley arrangement, so this listing names the two machines it fits. It is a shared part used across Tornado machines — see the full list of models below.

Its position in that sequence is what makes it worth ordering correctly. A washer in a pulley or motor-mount stack is often doing a dimensional job as well as a load-spreading one: it sets how far a component sits along a shaft or how a lock washer seats, and leaving it out or substituting a thicker one shifts the alignment of parts that need to run true.

Replace the X9374 if it is dished, cracked, galled on a face, burred at the bore, or corroded. On a motor-mount stack that is subject to continuous vibration, a washer that has started to dish will let the joint lose preload, and a joint that loses preload in the motor area is how a pulley starts to creep. If you find this washer polished bright on one face, something has been turning against it and the parts either side need inspecting too.

Fit it with the split lock washer and screw at the same callouts and keep the stack in the order the drawing shows. The washer is shared between the two 2000-series Brute Force machines and carries no model name. Call 763-535-0770 with your model and serial number if you want the motor hardware stack listed before ordering.

Compatible Models

Frequently asked questions

What does the washer (part# X9374) do on a burnisher?

It sits in the motor and motor-pulley hardware stack, spreading clamping load and helping set how the components in that stack seat against each other.

How do I know if my X9374 washer needs replacing?

Replace it if it is dished, cracked, galled, burred at the bore or corroded. A dished washer lets a motor-mount joint lose preload, which is how a pulley starts to creep on its shaft.

Does the X9374 fit the Brute Force 1600 (98458B)?

It is not listed on the 98458B drawing, which uses a different motor pulley arrangement. Work from the 98458B parts page for that machine.

What models is the washer (part# X9374) compatible with?

The Tornado Brute Force 2000 High-Speed Glazer (98482B) and the Brute Force 2000 Dust Control (98486).

How do I order the washer (part# X9374) or get help?

You can add the washer (part# X9374) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Motor Mount Washer X9374”

Your email address will not be published. Required fields are marked *