Tornado Rear Switch Box Cover X1463

$28.99

Genuine OEM rear switch box cover (part# X1463) for commercial high-speed burnishers — the back half of the handle-top switch enclosure. Fits all Tornado Brute Force burnishers (see full list below).

SKU: X1463 Category: Brand:

The X1463 is the rear switch box cover — the half of the handle-top enclosure that sits behind the switch and closes the box against the front cover (X1462). It appears on every drawing in the Brute Force burnisher book, on the Brute Force 1600 (98458B), on the Brute Force 2000 (98482B), and on the current and earlier Brute Force 2000 Dust Control (98486) drawings. It is a shared part used across Tornado machines — see the full list of models below.

Its job is containment and strain management. The rear half closes the enclosure around the switch wiring, and it is the half that the cord and conductors pass behind on their way down the handle. A cracked rear cover lets the wiring move where it should be held, and movement at a terminal is what eventually breaks a conductor or loosens a crimp.

Replace the X1463 if it is cracked, if the mounting bosses or screw threads have failed so the box no longer clamps shut, or if the two halves no longer meet cleanly along their seam. A box that does not close is not a cosmetic issue on a wet-use machine: it admits water and finish mist to a live switch. Also replace it if a previous repair has pulled the threads out and the cover is being held by one fastener — a single-fastener cover vibrates loose again quickly at burnishing speed.

Where both halves have years of service, fit the front (X1462) and rear covers together: a new half against a heat-set and distorted old half rarely seals along the seam. The threaded inserts (X1075) behind the covers are also worth checking while the box is open. This part is shared across the Brute Force line and carries no model name. Call 763-535-0770 if you want the switch-box set listed for your machine.

Compatible Models

Frequently asked questions

What does the rear switch box cover (part# X1463) do on a burnisher?

It closes the back of the handle-top switch enclosure against the front cover, containing the switch wiring and holding it where it cannot move against its terminals.

How do I know if my X1463 switch box cover needs replacing?

Replace it if it is cracked, if the screw bosses or threads have failed so the box will not clamp shut, or if the two halves no longer meet cleanly along the seam.

Should I replace both switch box covers at once?

If both are old, yes. A new half pressed against a distorted old half usually will not seal, so fitting the X1462 front and X1463 rear together saves a second teardown.

What models is the rear switch box cover (part# X1463) compatible with?

All three Tornado Brute Force burnishers: the 1600 (98458B), the 2000 High-Speed Glazer (98482B) and the 2000 Dust Control (98486).

How do I order the rear switch box cover (part# X1463) or get help?

You can add the rear switch box cover (part# X1463) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Rear Switch Box Cover X1463”

Your email address will not be published. Required fields are marked *