Screw M5 x 12 60140503

$1.99

Genuine OEM M5 x 12 mm screw (part# 60140503) for Tornado floor scrubbers. It is the general-purpose short M5 for plain two-part joints.

Genuine OEM M5 x 12 mm screw (part# 60140503) for Tornado floor scrubbers — the machines it fits are listed below. It is the general-purpose short M5: the length for a plain joint where a bracket or component sits flat against its mounting with nothing between them.

M5 occupies a useful middle ground on this machine. It is substantial enough to clamp properly — enough thread, enough head to grip — without the mass or torque of the structural M8s, so it is used wherever a component needs to be genuinely secure but is not carrying machine weight. That makes it one of the most common sizes on the electrical side.

The thing to get right is which M5 length belongs where, because the machine uses several and they are indistinguishable once they are loose in a tray. The usual error is reaching for whatever is to hand: in a shallow hole a longer screw bottoms out so the joint is loose while the wrench reads tight, and in a deep joint a shorter one leaves barely any thread engaged and lets go at the first hard knock.

Replace it when the drive recess or hex is rounded, when the thread is galled or damaged, when the shank is bent, or when there is a necked section under the head. Fit any washer the assembly calls for, and renew a lock washer rather than reusing a flattened one — a dead lock washer is the usual reason a joint that was tightened properly is loose again a month later.

Compatible Models

This part is shared across 8 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

Where is the screw (part# 60140503) used?

At plain joints where a bracket or component sits flat against its mounting with nothing between them. M5 is the size used where a component must be genuinely secure without carrying machine weight.

Why does the length matter if the thread is the same?

Because the machine uses several M5 lengths and they are indistinguishable once loose in a tray. Too long in a shallow hole bottoms out so the joint is loose while the wrench reads tight; too short in a deep joint leaves barely any thread engaged.

The joint keeps going loose. What should I replace?

The lock washer as well as the screw. A flattened lock washer is the usual reason a joint tightened properly is loose a month later. Also check the screw for a necked section under the head, which means it has been stretched.

How do I order the Screw M5 x 12 (part# 60140503) or get help?

You can add the Screw M5 x 12 (part# 60140503) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m5 x 12 (part# 60140503) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Screw M5 x 12 60140503”

Your email address will not be published. Required fields are marked *