Screw M5 x 35 60110513

$1.99

Genuine OEM M5 x 35 mm screw (part# 60110513) for Tornado floor scrubbers. It is the long M5 used where a component mounts through a deep stand-off.

Genuine OEM M5 x 35 mm screw (part# 60110513) for Tornado floor scrubbers — compatible machines are listed below. It is the long M5, used where a component is held clear of its mounting surface by a stand-off, a spacer or a bracket.

Electrical components are mounted that way for a reason: air has to move around a heat-producing device, and water has to be able to drain rather than sit between a board and a panel. The screw has to cross that whole gap and still engage proper thread, which is why the length is specific.

Fit something shorter and the thread engagement is marginal — it feels tight and lets go the first time the machine takes a hard knock. Fit this one where a short screw belongs and it either bottoms out, leaving the component loose while the driver reads tight, or protrudes into whatever is behind the panel.

Because it is long for its diameter, this is the M5 most likely to be bent rather than merely worn. Roll it on a flat surface before refitting: a bent screw through a stand-off stack puts a side load on everything it passes through and will not clamp the component square — which on a mounted board means a twist that can crack a solder joint months later.

Replace it when the drive recess or hex is rounded, the thread is galled or damaged along any part of its length, or there is a necked section below the head from over-tightening. Check the tapped hole before blaming the screw for a joint that will not stay tight.

Compatible Models

This part is shared across 4 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

Where is the screw (part# 60110513) used?

Where a component is held clear of its mounting surface by a stand-off, spacer or bracket, so the screw has to cross that gap and still engage proper thread.

Why are components mounted on stand-offs at all?

So air can move around a device that produces heat, and so water can drain rather than sit trapped between a board and a panel.

What should I check before refitting it?

Roll it on a flat surface. It is long for its diameter and therefore the M5 most likely to be bent, and a bent screw through a stand-off stack side-loads everything it passes through and will not clamp a board square.

How do I order the Screw M5 x 35 (part# 60110513) or get help?

You can add the Screw M5 x 35 (part# 60110513) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m5 x 35 (part# 60110513) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Screw M5 x 35 60110513”

Your email address will not be published. Required fields are marked *