Screw M5 x 8 60140501
$1.99
Genuine OEM M5 x 8 mm screw (part# 60140501) for Tornado floor scrubbers. It is the very short M5 used where the thread behind the mounting is shallow.
Genuine OEM M5 x 8 mm screw (part# 60140501) for Tornado floor scrubbers — compatible machines are listed below. At 8 mm it is the shortest M5 on the machine, chosen for positions where there is very little depth behind the mounting face.
Shallow is the key word, and it is usually shallow for a reason: a thin bracket, a blind boss in a moulding, or a panel with wiring directly behind it. In all three cases a longer screw is a problem. In a blind boss it bottoms out, so the driver reads tight while the component is still free to move. Behind a panel it can press into a harness or a connector, damage that is invisible from the front and shows up weeks later as an intermittent that nobody connects to a service.
The flip side is that a screw this short has little thread engaged, so it relies on the joint being clean and flat to hold. Fit it against a clean surface with the washer the assembly specifies, and do not try to make up for a poor joint with extra torque — at this engagement the thread will strip before the joint gets tighter.
Replace it when the drive recess is damaged, when the thread is galled, or when it no longer holds. In that last case check the host thread first: with only 8 mm engaged, a tired tapped hole is the likelier failure, and a stripped boss needs its own repair rather than another screw.
Compatible Models
- Tornado BD 26/27 — 99770
- Tornado BD 26/27 — 99772
- Tornado BR 28/27 — 99775
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BR 40/66 — 99795
- Tornado 99680blt — TS120-S53-U
This part is shared across 6 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
Where is the screw (part# 60140501) used?
Where there is very little depth behind the mounting face — a thin bracket, a blind boss in a moulding, or a panel with wiring directly behind it.
What happens if I use a longer M5?
In a blind boss it bottoms out, so the driver reads tight while the component is still loose. Behind a panel it can press into a harness or connector — damage invisible from the front that surfaces weeks later as an intermittent fault.
It will not hold. Should I tighten it harder?
No. With only 8 mm engaged the thread strips before the joint gets tighter. Check the tapped hole — a tired boss is the likelier failure, and it needs its own repair rather than another screw.
How do I order the Screw M5 x 8 (part# 60140501) or get help?
You can add the Screw M5 x 8 (part# 60140501) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m5 x 8 (part# 60140501) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet