Screw M8 x 40 60100812

$2.99

Genuine OEM M8 x 40 mm screw (part# 60100812) for Tornado floor scrubbers. It is the long M8 fastener in the steering group, sized to clamp a deep stack of brackets and spacers.

Genuine OEM M8 x 40 mm screw (part# 60100812) for Tornado floor scrubbers — the machines it fits are listed below. On the steering wheel assembly it is used where the fastener has to reach through a deeper stack than the short M8 screws elsewhere in the same group.

That depth is the reason it exists as its own part number. The steering group uses M8 screws at 12, 16 and 40 mm in different positions, and they are not substitutes for one another. A 40 mm screw put where a short one belongs will bottom out or project into something behind it; a short screw put here will not reach enough thread to hold a loaded joint, and the joint will be loose within weeks even though it felt tight on the wrench.

Treat it as a load-bearing fastener rather than a cover screw. Check it with a wrench at steering service and look for the signs that it has been working: a bright wear band on the shank, thread damage anywhere along its length, a slightly necked section below the head where it has stretched, a rounded drive recess, or any bend. Roll it on a flat surface — bends here are easy to miss by eye and they prevent the stack clamping square.

When refitting, make sure every spacer and washer that came out goes back in. The length is specified for the complete stack, so a joint reassembled a washer short is effectively using a screw that is too long, and it will bottom before clamping.

This is the genuine Tornado part in the correct length, diameter and head form, so the joint clamps properly on full thread engagement.

Compatible Models

This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the steering wheel drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

Where is the screw (part# 60100812) used on a Tornado floor scrubber?

On the steering wheel assembly, at a position where the fastener has to clamp a deeper stack of brackets and spacers than the shorter M8 screws used elsewhere in the same group.

Can I substitute another M8 screw?

No. The steering group uses M8 screws at several lengths and they are not interchangeable. Too long and it bottoms out or projects behind; too short and it does not reach enough thread to hold a loaded joint.

How do I know if the screw (part# 60100812) needs replacing?

Look for a bright wear band on the shank, thread damage anywhere along its length, a necked section below the head from stretching, a rounded drive recess, or a bend — roll it on a flat surface to check that last one.

How do I order the Screw M8 x 40 (part# 60100812) or get help?

You can add the Screw M8 x 40 (part# 60100812) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m8 x 40 (part# 60100812) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Screw M8 x 40 60100812”

Your email address will not be published. Required fields are marked *