Solution Control Knob 61810014
$8.99
Genuine OEM solution control knob (part# 61810014) for Tornado floor scrubbers. It is the knob the operator turns to set how much solution the machine lays down.
Genuine OEM solution control knob (part# 61810014) for Tornado floor scrubbers — compatible machines are listed below. It is the knob on the operator’s side of the machine that sets solution flow, connected by a rod down to the valve in the solution line.
It is a small plastic part with an outsized effect on how the machine gets used. If the knob is cracked, spins on its shaft, or has lost the detent feel it had when new, the operator can no longer set flow reliably — so they tend to run the machine at whatever setting it happens to be at. That means either a floor being scrubbed too dry, which cleans badly and chews brushes, or solution being laid down faster than the squeegee can recover it, which leaves water behind and empties the tank halfway through a run.
Knobs fail by being handled thousands of times with wet, gritty gloves, and by being knocked. The usual faults are a split hub, a stripped or rounded drive feature so the knob turns without moving the rod, and surface wear that makes any printed markings unreadable.
Before replacing one, check whether the problem is the knob or what it is connected to. A knob that turns freely through its full range with no effect at all points at a disconnected or bent control rod, or a valve that has seized, rather than at the knob itself. A knob that binds part-way usually means the rod is bent or the valve mechanism is stiff with scale or dried detergent.
This is the genuine Tornado knob, sized for the shaft and with the correct drive, so the full range of the valve is actually available to the operator.
Compatible Models
- Tornado BD 26/30 — 99760
- Tornado BR 28/30 — 99765
- Tornado BD 26/27 — 99770
- Tornado BR 33/30 — 99785
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
This part is shared across 5 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the water filter drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the solution control knob (part# 61810014) do?
It is the operator’s solution flow control. Turning it moves a rod down to the valve in the solution line, setting how much water the machine lays down.
Why does a worn knob matter?
Because the operator stops being able to set flow reliably and just runs the machine wherever it happens to be. That means either scrubbing too dry — bad cleaning and fast brush wear — or laying down more water than the squeegee can recover.
My knob turns but nothing changes. Is the knob at fault?
Not necessarily. A knob that turns freely through its full range with no effect points at a disconnected or bent control rod or a seized valve. A knob that binds part-way usually means a bent rod or a valve stiff with scale or dried detergent.
How do I order the Solution Control Knob (part# 61810014) or get help?
You can add the Solution Control Knob (part# 61810014) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the solution control knob (part# 61810014) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet