Solution Fill Hose 47610470

$87.99

Genuine OEM solution fill hose (part# 47610470) for Tornado floor scrubbers. It carries water from the fill point into the solution tank.

Genuine OEM solution fill hose (part# 47610470) for Tornado floor scrubbers — the machines it fits are listed below. It runs from the fill point into the solution tank, and it is the hose that takes the abuse of every tank fill the machine ever gets.

That abuse is worth understanding, because it shapes how the hose fails. Fills are done quickly, often from a hose or a tap running hard, so the hose sees pressure surges rather than the steady low-pressure flow the rest of the solution circuit sees. It is also handled: pulled, bent back on itself, and occasionally stood on. And it carries whatever is in the building’s water, so scale builds up inside it over years.

The symptoms are straightforward. A split or a weeping joint puts water into the machine during fills — often blamed on careless filling for months before anyone looks at the hose. A kink or a collapsed section slows filling noticeably, which matters when a crew is turning machines around between shifts. And a hose that has gone hard will not reseal on its fittings, so a joint that was fine before a service starts weeping after it.

Inspect it at service with the tank being filled, which is the only time the fault is visible: look for weeping at both ends, a bulge or split along the length, and kinks that do not spring out when released. Replace rather than patch — a patched fill hose fails again in the same place — and fit new clamps, tightening to seal only.

Compatible Models

This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the solution tank drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the solution fill hose (part# 47610470) do?

It carries water from the fill point into the solution tank, taking the pressure surges and handling of every tank fill the machine gets.

Water appears inside the machine when we fill it. Is this the hose?

Very often, yes — a split or weeping joint on the fill hose. It tends to get blamed on careless filling for months before anyone inspects the hose.

When should I inspect it?

At service, while the tank is actually being filled — that is the only time the fault is visible. Look for weeping at both ends, a bulge or split along the length, and kinks that do not spring out. Replace rather than patch; a patched fill hose fails again in the same place.

How do I order the Solution Fill Hose (part# 47610470) or get help?

You can add the Solution Fill Hose (part# 47610470) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the solution fill hose (part# 47610470) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Solution Fill Hose 47610470”

Your email address will not be published. Required fields are marked *