Spacer 47007110

$11.99

Genuine OEM spacer (part# 47007110) for Tornado floor scrubbers. It sets the axial position of a shaft or bearing in the steering group, holding the stack at the length the assembly was designed around.

Genuine OEM spacer (part# 47007110), used on a range of Tornado floor scrubbers — the machine list is below. In the steering group it is a dimensional part rather than a wearing one: its job is to occupy a precise length along a shaft so that the bearings, hubs and retaining hardware either side of it end up exactly where they belong.

Spacers are easy to underrate because they do nothing visible. What they actually control is preload and clearance. Leave one out and the retaining hardware clamps the stack shorter than it should be, which either pinches a bearing or lets a hub float; fit the wrong length and the same thing happens by a smaller margin. Both show up as a steering assembly that is either tight or sloppy, and both get misdiagnosed as a bearing fault.

Inspect it whenever the shaft is apart. Look for scoring on the end faces, a face that is no longer square, burring at the bore from being driven on, or any reduction in length against a new part — a spacer that has been running against a moving component can wear measurably. Check for cracks too, particularly at the bore, since a cracked spacer collapses under clamp load and silently shortens the stack.

When reassembling, count the parts off as they come apart and lay them in order. The most common fault with spacers is not wear at all but omission during a rushed rebuild, and the resulting play gets chased through bearings and retaining rings for hours before anyone counts what went back in.

This is the genuine Tornado part at the correct length and bore, so the steering stack goes back to its designed dimensions.

Compatible Models

This part is shared across 3 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the steering wheel drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the spacer (part# 47007110) do on a Tornado floor scrubber?

It occupies a precise length along a shaft in the steering group so that the bearings, hubs and retaining hardware either side of it sit exactly where the design intends, setting clearance and preload.

What happens if it is left out or the wrong one is fitted?

The retaining hardware clamps the stack shorter than it should be, which either pinches a bearing or lets a hub float. Both show up as steering that is tight or sloppy, and both are commonly misdiagnosed as a bearing fault.

How do I know if the spacer (part# 47007110) needs replacing?

Check the end faces for scoring or being out of square, the bore for burring or cracks, and the overall length against a new part. A cracked spacer collapses under clamp load and silently shortens the stack.

How do I order the Spacer (part# 47007110) or get help?

You can add the Spacer (part# 47007110) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the spacer (part# 47007110) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Spacer 47007110”

Your email address will not be published. Required fields are marked *