Tornado Standoff Spacer X8822

$2.99

Genuine OEM standoff spacer (part# X8822) for commercial high-speed burnishers — sets the gap in the joint clamped by the X8821 bolt. Fits the Tornado Brute Force 1600 (98458B) and Brute Force 2000 (98482B).

SKU: X8822 Category: Brand:

The X8822 is the spacer listed with the #8-32 bolt (X8821) on the Brute Force 1600 (98458B) and Brute Force 2000 (98482B) drawings — shown on the 98458B and on the 98482B, in each case immediately after the bolt. It is not listed on either Brute Force 2000 Dust Control (98486) drawing. It is a shared part used across Tornado machines — see the full list of models below.

A spacer is a dimensional part, not a filler. Its length sets the distance between the two components it separates, and that distance has been chosen for a reason: clearance for a moving part, alignment of a bracket, or the correct standoff for an electrical component. A spacer that is the wrong length, crushed, or left out entirely changes that dimension and the part it was positioning goes out of place.

Replace the X8822 if it is crushed, split, deformed at the ends, or corroded. The important check is length: compare it against a new one if you have any doubt, because a spacer that has been progressively compressed by over-tightening can be measurably shorter than it should be while still looking serviceable. Also look at the bearing faces at each end — a spacer that has been turning under a bolt head will be dished and will no longer hold its dimension under load.

Never substitute washers stacked up for a missing spacer: the stack compresses differently and will not hold the dimension. Order the bolt (X8821) with it where the bolt is also tired. The part is shared between the two non-dust-control Brute Force machines and carries no model name. Call 763-535-0770 with your model and serial number if you want the joint hardware listed.

Compatible Models

Frequently asked questions

What does the standoff spacer (part# X8822) do on a burnisher?

Its length sets the gap between the two parts it separates in the joint clamped by the X8821 bolt — it is a dimensional part, not a filler.

How do I know if my X8822 spacer needs replacing?

Replace it if it is crushed, split, deformed or corroded. Compare its length with a new one: progressive over-tightening can shorten a spacer measurably while it still looks usable.

Can I stack washers instead of fitting a spacer?

No. A stack of washers compresses differently and will not hold the dimension the spacer was chosen to set, so the part it positions ends up out of place.

What models is the standoff spacer (part# X8822) compatible with?

The Tornado Brute Force 1600 (98458B) and the Brute Force 2000 High-Speed Glazer (98482B).

How do I order the standoff spacer (part# X8822) or get help?

You can add the standoff spacer (part# X8822) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Standoff Spacer X8822”

Your email address will not be published. Required fields are marked *