T-Fitting 62330040
$15.74
Genuine OEM 90-degree T-fitting (part# 62330040), 1/2 in. female, for Tornado floor scrubbers. It splits the solution line so one feed can serve two destinations.
Genuine OEM T-fitting (part# 62330040), a 90-degree 1/2 inch female tee, for Tornado floor scrubbers — compatible machines are listed below. In the water filter assembly it splits the solution line, taking one feed and sending it two ways.
A tee is a pressure-drop component as much as a plumbing convenience. The branch geometry determines how the flow divides, which is why a correct fitting matters: substitute a tee with a different internal profile and one leg can end up starved while the other runs strong, giving a machine that wets one side of the deck properly and the other poorly. Chasing that symptom at the brushes or the valve is a long afternoon.
Plastic fittings in a solution line fail in a few recognisable ways. They crack at a threaded boss, almost always from over-tightening or from someone using the fitting as a handle while pulling a hose off; the crack is often hairline and only weeps under flow. They become brittle with age and chemical exposure, so a fitting that has been in service for years can break when a hose is next removed. And their barbs wear smooth where a clamp has crushed the hose repeatedly, after which no clamp will hold that joint tight.
Inspect it any time a hose at this fitting is disturbed. Look for hairline cracks around the threads and barbs, check that the barbs still have sharp ridges, and replace rather than reuse a fitting that has been over-tightened. Fit hoses with the correct clamps and tighten to seal only.
Compatible Models
- Tornado BD 26/27 — 99772
- Tornado BR 28/27 — 99775
- Tornado BD 33/30 — 99780
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
This part is shared across 4 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the water filter drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the T-fitting (part# 62330040) do?
It splits the solution line in the water filter assembly, taking one feed and sending it two ways. It is a 90-degree 1/2 inch female tee.
Does it matter if I use a different tee?
Yes. The branch geometry determines how flow divides, so a tee with a different internal profile can starve one leg — giving a machine that wets one side of the deck well and the other poorly, which is a long fault to chase elsewhere.
How do plastic fittings like this fail?
They crack at a threaded boss from over-tightening or from being used as a handle when pulling a hose off — often a hairline crack that only weeps under flow. They also grow brittle with age and chemical exposure, and their barbs wear smooth where clamps have crushed the hose repeatedly.
How do I order the T-Fitting (part# 62330040) or get help?
You can add the T-Fitting (part# 62330040) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the t-fitting (part# 62330040) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet