Tornado Brute Force 2000 98486 Dust Skirt Clamp X1469

$4.99

Genuine OEM dust skirt clamp (part# X1469) for the Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486 — the clamp that holds the dust control skirt to the shroud. Shown on the current main body drawing.

SKU: X1469 Category: Brand:

The X1469 dust skirt clamp holds the dust control skirt (X1461) against the shroud on the Brute Force 2000 Dust Control glazer (Model 98486). It appears on the current 14 July 2025 main body drawing and on the earlier 29 December 2022 main assembly. It is specific to the dust-control machine, which is why this listing names the model. It is a shared part used across Tornado machines — see the full list of models below.

The clamp is the part that determines whether a good skirt actually seals. It has to hold the skirt flat against the shroud all the way round, with no gaps where the skirt can lift under the pressure difference the machine creates. A clamp that has lost its grip at one point produces a local leak, and a local leak is enough to let the machine pull its air through the gap instead of across the pad.

Replace the X1469 if it is bent, cracked, corroded, or no longer develops clamping pressure when the hardware is tightened, and replace it whenever the fasteners that hold it have pulled through or stripped. The diagnostic trick is to look at the skirt with the clamp tight: if there is daylight between the skirt and the shroud anywhere, or the skirt can be pulled away by hand at any point, the clamp is the part at fault even when the skirt itself is new.

Fit it with a new skirt where the skirt is also worn — the two parts are a sealing system rather than two independent components, and renewing one against a worn other usually disappoints. Call 763-535-0770 with your model and serial number if you want the dust-control parts listed for your machine.

Compatible Models

Frequently asked questions

What does the dust skirt clamp (part# X1469) do on the Tornado 98486?

It holds the dust control skirt flat against the shroud all the way round, so the skirt cannot lift and let air leak past instead of being drawn across the pad.

How do I know if my X1469 dust skirt clamp needs replacing?

With the clamp tightened, look for daylight between the skirt and the shroud, or a point where the skirt can be pulled away by hand. Also replace it if it is bent, cracked, corroded or the fastener holes have pulled through.

I fitted a new skirt and it still leaks — what should I check?

The clamp. A new skirt held by a tired clamp seals no better than the old one. Check for gaps all the way round and renew the clamp with the skirt where both are worn.

What models is the dust skirt clamp (part# X1469) compatible with?

The Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486, on both its current and earlier drawings.

How do I order the dust skirt clamp (part# X1469) or get help?

You can add the dust skirt clamp (part# X1469) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Brute Force 2000 98486 Dust Skirt Clamp X1469”

Your email address will not be published. Required fields are marked *