Tornado Brute Force Burnisher Pads and Pad Driver

Find genuine Tornado Brute Force burnisher pads and pad driver replacement parts for Model 98458B, 98482B and 98486. Can’t find your part? Call us at 763-535-0770.

Click any numbered dot on the diagram to jump straight to that part, or use the table below the drawing.

This sheet is common to all three Brute Force burnishers — the 1600 RPM 98458B and the 2000 RPM 98482B and 98486 — because every one of them takes the same 20-inch pads and the same flexible pad driver. The driver (X8862) is the part the pad mounts to, and it is held on by the right-hand-thread centre lock (F44P). The pads above it run from aggressive scuff removal through to high-gloss burnishing, and choosing the right one matters more to the finish than anything else on the machine. One pad in the book, the 20-inch microfiber pad MF20, is marked no longer available by the manufacturer.

#ImagePart DescriptionPart NumberPrice
1—20″ Microfiber Burnishing Pad (Case of 2) (NLA)MF20Call 763-535-0770
220 Porko Burnishing Floor Pad (Case of 5) PP052020″ Porko Burnishing Floor Pad (Case of 5)PP0520$72.99
3—20″ Combo Floor Pad (Case of 5)CB520Call 763-535-0770
4—20″ Beige Burnishing Pad Case of 5IB520Call 763-535-0770
5—20″ Luster Lite Floor Pad (Case of 5)LL520Call 763-535-0770
6—20″ Porko Floor Pad (Case of 5)PK520Call 763-535-0770
7—20″ Scuff Remover Floor PadRP020Call 763-535-0770
820 Flexible Pad Driver X886220″ Flexible Pad DriverX8862$268.99

Brute Force burnisher pad questions

Do all three Brute Force burnishers take the same pads?

Yes. The 98458B, 98482B and 98486 all use 20-inch pads on the same flexible pad driver, part# X8862, so this sheet applies to the whole range.

Which pad should I use for a high-gloss finish?

The burnishing pads — the Porko burnishing pad, the beige burnishing pad or the Luster Lite — are the finishing pads. The scuff remover is for taking marks out before you burnish, not for the final pass.

What holds the pad onto the driver?

The right-hand-thread pad retainer centre lock, part# F44P. It threads into the centre of the X8862 driver. If a pad is coming loose mid-pass, that lock is the first thing to check.

Is the MF20 microfiber pad still available?

No. The manufacturer marks the 20-inch microfiber burnishing pad as no longer available. Call 763-535-0770 and we will recommend the closest current pad for your finish.

These pads fit the 98458B, the 98482B and the 98486. See all Tornado Brute Force burnisher parts.