CleanMax Hall Sensor PC Board B317-1000BK
$66.99
Genuine CleanMax ZM-700 PC board for the Hall sensor (part# B317-1000BK). Reads motor position/speed for the control system. Call 763-535-0770.
The ZM-700 PC Board for Hall Sensor (part# B317-1000BK) is the printed circuit board that carries the Hall-effect sensor on the CleanMax ZM-700 commercial battery upright. The Hall sensor reports the brushless motor’s rotor position and speed to the control electronics, which is how the machine drives and regulates its motor.
Compatible Models for the ZM-700 Hall Sensor PC Board
This is a genuine Tacony OEM part for the CleanMax ZM-700 commercial battery upright. Call 763-535-0770 if you are unsure which model or configuration you have and we will confirm the correct part.
What the ZM-700 Hall Sensor PC Board does
On a brushless DC commercial vacuum, the control board needs to know exactly where the motor’s rotor is to energize the windings in the right sequence. This Hall-sensor PC board provides that feedback, letting the controller run the motor smoothly and at the correct speed. Without a working Hall board the controller cannot commutate the motor properly, so the motor may stutter, fail to start, or shut down. It is a precision electronic part matched to the ZM-700’s motor and controller.
Signs the ZM-700 Hall Sensor PC Board needs replacing
Replace the Hall sensor board if the ZM-700 motor will not start, starts and stops erratically, runs rough or noisy, or throws a motor fault while the battery and wiring test good. Visible damage, burnt components, or corrosion on the board are clear reasons to replace it. Because it is a control-feedback part, symptoms often mimic a motor problem — confirm the board before condemning the motor.
Installation and fit
Power down and isolate the battery before opening the motor area. Note the board’s orientation and connector, transfer the connection to the new board exactly, mount it in the same position and alignment to the motor, and confirm the motor runs smoothly before returning the machine to service. Twin City Vacuum has sold and serviced CleanMax equipment since 1956, and every part is sourced directly from Tacony. Browse more CleanMax parts, or learn more at CleanMax.
Frequently Asked Questions
What does the Hall Sensor PC Board do on the CleanMax ZM-700?
It carries the Hall-effect sensor that reports the brushless motor’s rotor position and speed to the control board, which the controller needs to drive and regulate the motor.
How do I know if my ZM-700 Hall Sensor PC Board needs replacing?
Replace it if the motor will not start, stutters or runs rough, or throws a motor fault while the battery and wiring test good, or if the board shows burnt components or corrosion.
What models is the Hall Sensor PC Board (part# B317-1000BK) compatible with?
It is the genuine Hall sensor PC board for the CleanMax ZM-700 commercial battery upright. Call 763-535-0770 to confirm fit for your machine.
How do I order the Hall Sensor PC Board (part# B317-1000BK) or get help?
You can add the Hall Sensor PC Board (part# B317-1000BK) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing CleanMax equipment since 1956 and can help confirm the right part for your machine.
Questions? Call us at 763-535-0770 or visit 5415 West Broadway, Crystal, MN 55428.
