Plastic Strain Relief X8008P
$13.99
Genuine Tacony OEM plastic strain relief (part# X8008P) for the Tornado Marathon SE 900 (Model 98170) and Powr-Flite Prowler PFX900S. A non-conductive cord grip for panel entries where an insulating body is what the design calls for.
The Plastic Strain Relief (part# X8008P) is a genuine Tacony OEM replacement part from the recovery and solution tank assembly of the Tornado Marathon SE 900 self-contained carpet extractor. It is the moulded plastic cord grip that secures a cable through a panel opening and protects it from the panel edge.
What the Plastic Strain Relief does
A plastic relief does two things a metal one does not. Its body is an insulator, so it cannot become a conductive path at a panel entry, and its moulded shoulder gives the cable a radiused bearing surface instead of a sheared sheet-metal edge. Over thousands of flex cycles that radius is what keeps the jacket from being sawn through at the point it enters the machine.
When to replace the Plastic Strain Relief (X8008P)
Replace it when the body or its locking fingers are cracked, when it has gone chalky and brittle from age and chemical exposure, or when the cable slides in it. Plastic that has been overtightened often splits at the hinge and only shows it once the cable is pulled.
Plastic Strain Relief X8008P — fitment and installation notes
Match the relief to the cable diameter rather than forcing an oversized cable through, and seat it fully so the locking fingers latch on the far side of the panel. Do not add heat or solvent to persuade it into the hole, since both make the plastic brittle exactly where it needs to stay tough. Tacony builds the Tornado Marathon SE 900 and the Powr-Flite Prowler PFX900S on a single machine platform, so this component carries across both brands rather than belonging to either one. It is a shared Tacony component and may fit additional models beyond those listed — call us and we will confirm against your serial number.
Compatible Models for the Plastic Strain Relief
- Tornado Marathon SE 900 — Model 98170
- Powr-Flite Prowler PFX900S
- Powr-Flite PFX900SG
Twin City Vacuum has been selling and servicing commercial floor-care equipment since 1956 from 5415 West Broadway, Crystal, MN 55428. We stock genuine Tacony parts and ship nationwide. Browse the full Tornado 98170 parts catalogue, or see the manufacturer at tornadovac.com.
Frequently Asked Questions
What does the Plastic Strain Relief do on the Tornado Marathon SE 900?
A plastic relief does two things a metal one does not. Its body is an insulator, so it cannot become a conductive path at a panel entry, and its moulded shoulder gives the cable a radiused bearing surface instead of a sheared sheet-metal edge. Over thousands of flex cycles that radius is what keeps the jacket from being sawn through at the point it enters the machine.
How do I know if my Plastic Strain Relief needs replacing?
Replace it when the body or its locking fingers are cracked, when it has gone chalky and brittle from age and chemical exposure, or when the cable slides in it. Plastic that has been overtightened often splits at the hinge and only shows it once the cable is pulled.
What models is the Plastic Strain Relief (part# X8008P) compatible with?
The Tornado Marathon SE 900 (Model 98170), the Powr-Flite Prowler PFX900S and the PFX900SG. It is a shared Tacony part and may fit further models; call us to confirm.
How do I order the Plastic Strain Relief (part# X8008P) or get help?
You can add the Plastic Strain Relief (part# X8008P) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
