Actuator Pin 21703030

$30.99

Genuine OEM actuator pin (part# 21703030) for Tornado floor scrubbers. It is the clevis pin that connects the deck actuator to its linkage.

Genuine OEM actuator pin (part# 21703030) for Tornado floor scrubbers — the machines it fits are listed below. It is the pin that connects the brush deck actuator to the linkage it drives, retained by a clip.

It is a small part at a high-load, high-cycle joint. Every time the deck is raised or lowered, the actuator’s whole force goes through this pin, and the deck is raised and lowered many times a shift — at every turn-around, every aisle end, every time the operator lifts to cross something. On top of that, it sits directly above the brushes in solution spray and floor grit.

Wear here shows up as play. A pin worn flat on its loaded side, or a hole gone oval around it, lets the deck drop a little before the actuator takes the load, so the deck lands with a knock instead of settling. That knock then accelerates the wear, and it also makes brush pressure less repeatable, since the deck is no longer stopping in quite the same place.

The other failure is the retaining clip, not the pin: if the clip is missing or has lost its spring, the pin works its way out, and the deck drops with no warning. Always fit a new clip with a new pin.

Inspect it whenever the actuator or linkage is apart: roll the pin on a flat surface to check it is straight, look for a flat worn on one side and for scoring, and check both holes it passes through for ovality. A new pin in an ovalled hole will not take the play out.

Compatible Models

This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the brush base control drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the actuator pin (part# 21703030) do?

It connects the brush deck actuator to the linkage it drives. The actuator’s whole force passes through this pin every time the deck is raised or lowered.

My deck drops with a knock instead of settling. Why?

Play at this joint. A pin worn flat on its loaded side, or an ovalled hole, lets the deck fall slightly before the actuator takes the load — and that also makes brush pressure less repeatable, since the deck stops in a slightly different place each time.

Should I replace the retaining clip too?

Always. If the clip is missing or has lost its spring the pin works its way out and the deck drops with no warning. Check both holes the pin passes through for ovality at the same time — a new pin in an ovalled hole will not take the play out.

How do I order the Actuator Pin (part# 21703030) or get help?

You can add the Actuator Pin (part# 21703030) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the actuator pin (part# 21703030) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Actuator Pin 21703030”

Your email address will not be published. Required fields are marked *