Tornado Axle 13-3/4 in. X8936

$13.99

Genuine OEM 13-3/4 in. axle (part# X8936) for commercial high-speed burnishers — the short transport axle on the Tornado Brute Force 1600 (98458B) and Brute Force 2000 (98482B).

SKU: X8936 Category: Brand:

The X8936 is a 13-3/4 inch transport axle. It appears on the Brute Force 1600 (98458B) main assembly drawing and on the Brute Force 2000 (98482B) drawing. The Brute Force 2000 Dust Control (98486) drawings do not list it — that machine uses the X1460 axle in the equivalent 13-3/4 inch length — so this listing names the two machines it fits. It is a shared part used across Tornado machines — see the full list of models below.

These machines carry more than one axle, and the lengths are close: 13-3/4 inches here against 14-1/2 inches for the X8816. Three quarters of an inch is easy to miss on a bench, and an axle that is too short will not pick up both retainers while one that is too long fouls what sits beside it, so the callout number is the only safe way to order.

Replace the X8936 if the shaft is bent, if it has worn a step where the wheels ride, if it is scored, or if it is pitted from corrosion. Bending shows up as a machine that crabs instead of rolling straight and as wheels that visibly wobble; wear shows up as side-to-side play that lets the machine rock when it is set down. Grit, stripper and floor finish work into the wheel bore and lap the axle down over time, so machines used for stripping work wear axles faster than those used only for burnishing.

Fit new wheels with a new axle unless the wheels are clearly good, and replace the spring washer (X8101) and retaining hardware at the same callout as a matter of routine. The axle is shared between the two non-dust-control Brute Force machines and carries no model name. Call 763-535-0770 with your model and serial number if you want the length listed before ordering.

Compatible Models

Frequently asked questions

What does the 13-3/4 in. axle (part# X8936) do on a burnisher?

It is a transport axle carrying the machine’s weight on its wheels when the burnisher is tilted back and rolled.

How do I know if my X8936 axle needs replacing?

Replace it if the machine crabs rather than rolling straight, if the wheels wobble, if there is side-to-side play not explained by the wheels, or if the shaft is bent, stepped, scored or pitted.

How is the X8936 different from the X8816 axle?

Length. The X8936 is 13-3/4 inches and the X8816 is 14-1/2 inches. Order by the callout number on your drawing, not by appearance.

What models is the 13-3/4 in. axle (part# X8936) compatible with?

The Tornado Brute Force 1600 (98458B) and the Brute Force 2000 High-Speed Glazer (98482B). The 98486 dust-control glazer uses the X1460 axle instead.

How do I order the axle (part# X8936) or get help?

You can add the axle (part# X8936) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Axle 13-3/4 in. X8936”

Your email address will not be published. Required fields are marked *