Lever 61820006

$1.99

Genuine OEM lever (part# 61820006) for Tornado floor scrubbers. It is the small lever in the solution control linkage that converts the control’s movement into valve movement.

Genuine OEM lever (part# 61820006) for Tornado floor scrubbers — the machine list is below. It is the small lever in the solution control linkage, the piece that takes the movement coming down from the operator’s control and applies it to the valve.

Linkage parts are easy to overlook because nothing about them looks like it could be the problem, and they are where a surprising number of solution-flow complaints actually live. The whole control is a chain: knob, rod, lever, valve. A fault anywhere in that chain produces the same symptom at the operator’s end — the control moves and the flow does not do what it should — so it pays to work along the chain rather than replacing the most expensive component first.

This lever fails in three ways worth knowing. It can crack or break at its pivot or at the point where the rod engages it, usually after years of being worked wet. It can wear at the engagement point so there is lost motion: the control moves a few degrees before the valve starts to respond, and the full range of the valve is no longer reachable. And it can seize on its pivot with dried detergent and scale, which makes the control stiff and encourages someone to force it, breaking something more expensive.

Check it with the control worked by hand: the lever should move freely through the whole stroke, with no slop at the rod and no flex in the lever itself. Clean the pivot rather than forcing a stiff one, and replace a lever showing any crack — it will fail at the worst moment.

Compatible Models

This part is shared across 6 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the water filter drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the lever (part# 61820006) do?

It is the piece in the solution control linkage that takes the movement coming down from the operator’s control and applies it to the valve.

My solution control feels vague or has slack in it. Could this be it?

Yes. A worn engagement point on the lever gives lost motion — the control moves a few degrees before the valve responds, and the valve’s full range is no longer reachable. Work the control by hand and watch for slop at the rod.

The control is stiff. Should I force it?

No. A lever seized on its pivot with dried detergent and scale is what usually causes that, and forcing the control breaks something more expensive. Clean the pivot, and replace the lever if it shows any crack.

How do I order the Lever (part# 61820006) or get help?

You can add the Lever (part# 61820006) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the lever (part# 61820006) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Lever 61820006”

Your email address will not be published. Required fields are marked *