Tornado Main Pulley X8096

$109.99

Genuine OEM main pulley (part# X8096) for commercial high-speed burnishers — the driven pulley that takes the V-belt and turns the pad drive shaft. Fits all Tornado Brute Force burnishers (see full list below).

SKU: X8096 Category: Brand:

The X8096 is the main (driven) pulley in the pad drive of the Brute Force burnishers. It appears on the Brute Force 1600 (98458B) main assembly drawing, and on the Brute Force 2000 machines it appears as a sub-callout inside the main pulley assembly — shown on the 98482B drawing and on both 98486 drawings — which means it is supplied as part of the X8096A assembly on those machines and is also available on its own, as here. It is a shared part used across Tornado machines — see the full list of models below.

The pulley converts belt tension into pad torque. Its V-groove has to grip the belt over its whole flank; the moment the groove wears into a polished U shape, or the flanks pick up a layer of baked finish dust, the belt rides on the bottom of the groove and slips. On a 2,000 RPM machine that slip costs pad speed immediately and gloss straight after.

Replace the X8096 when the groove is worn wide or glazed, when the flanks are chipped or cracked, when the bore or keyway is worn so the pulley moves on the shaft, or when the pulley has visible run-out. The classic symptom is belt dust and a squeal on start-up that goes away once the machine is up to speed, together with a belt that needs replacing far too often. Fitting belt after belt into a worn groove is the single most common mistake on these machines: the belt is not the problem.

When you fit a new pulley, fit a new V-belt (X8099-5) with it and check the rubber ball bearing (X8098) and the motor pulley (X9298 on the 2000 machines, X8889 on the 1600). Clean the groove of any finish build-up at every service — it costs nothing and doubles belt life. The pulley is shared across the Brute Force line and carries no model name; call 763-535-0770 if you want it listed for your machine.

Compatible Models

Frequently asked questions

What does the main pulley (part# X8096) do on a burnisher?

It is the driven pulley: the V-belt from the motor turns it, and it drives the shaft that carries the pad driver and the pad.

How do I know if my X8096 main pulley needs replacing?

Replace it if the V-groove is worn wide or glazed, the flanks are chipped, the bore or keyway lets the pulley move on the shaft, or the pulley shows visible run-out. Squealing on start-up plus short belt life is the classic sign.

My belts keep failing — is it the belt or the pulley?

If new belts keep failing, suspect the pulley groove. A worn or glazed groove lets the belt ride on the bottom and slip, which cooks the belt. Replacing belts into a worn groove is the most common wasted repair on these machines.

What models is the main pulley (part# X8096) compatible with?

All three Tornado Brute Force burnishers: the 1600 (98458B), the 2000 High-Speed Glazer (98482B) and the 2000 Dust Control (98486). On the 2000 machines it is also supplied inside the X8096A pulley assembly.

How do I order the main pulley (part# X8096) or get help?

You can add the main pulley (part# X8096) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Tornado Main Pulley X8096”

Your email address will not be published. Required fields are marked *