Potentiometer 63415014
$561.99
Genuine OEM potentiometer (part# 63415014) for Tornado stand-on floor scrubbers. It reads steering or speed position on the steering column and feeds that signal to the drive controller.
Genuine OEM potentiometer (part# 63415014) for Tornado stand-on floor scrubbers — the machines it fits are listed below. Mounted in the steering wheel group, it converts a mechanical position into an electrical signal the drive controller can read.
A potentiometer is a resistive track with a wiper sweeping along it, which makes it one of the few genuinely consumable electronic parts on the machine. The wiper is in physical contact with the track and the track wears, so the positions the machine passes through most often wear first. On a scrubber that is the middle of the range, where the machine spends most of its life running straight at working speed.
That wear pattern is what makes the symptoms distinctive. The machine behaves normally at the extremes but becomes erratic in the middle: it surges or stutters at steady speed, it hesitates coming off a stop, or the drive cuts out briefly and recovers. Controller fault codes relating to an out-of-range or implausible input point here too. Before replacing it, check the connector and the wiring — a corroded pin or a chafed wire produces identical symptoms and is far cheaper to fix.
When fitting a new one, pay attention to the mechanical setup as well as the electrical connection. A potentiometer that is mounted a few degrees out works at one end of its travel and runs out at the other, and that shows up as a machine that is fine turning one way and poor turning the other. Follow the setup procedure rather than bolting it on and hoping.
This is the genuine Tornado part, matched to the resistance range the controller expects, so the drive responds the way the machine was calibrated to.
Compatible Models
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BD 40/66 — 99790
- Tornado BR 40/66 — 99795
This part is shared across 3 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the steering wheel drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the potentiometer (part# 63415014) do on a Tornado stand-on scrubber?
It converts a mechanical position in the steering wheel group into an electrical signal for the drive controller, so the controller knows what the operator is asking for.
My machine surges or cuts out at steady speed but is fine at full lock. Is this the part?
That is the classic worn-potentiometer pattern. The wiper wears the track where the machine spends most of its time, which is the middle of the range, so the extremes still read correctly while the middle goes erratic.
What should I check before replacing it?
The connector and the wiring. A corroded pin or a chafed wire gives identical symptoms and costs almost nothing to fix. Also note that a potentiometer mounted a few degrees out will work at one end of its travel and run out at the other, so follow the setup procedure when fitting.
How do I order the Potentiometer (part# 63415014) or get help?
You can add the Potentiometer (part# 63415014) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the potentiometer (part# 63415014) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet