Rear Center Squeegee Blade Holder Assembly V8307050

$163.99

Genuine OEM rear center squeegee blade holder assembly (part# V8307050) for the Tornado BDSO 27/28. It is the centre blade holder supplied complete and ready to fit.

Genuine OEM rear center squeegee blade holder assembly (part# V8307050) for the Tornado BDSO 27/28 stand-on scrubber. It is supplied as a complete assembly rather than as a bare strip, which is the right way to replace it: the holder’s geometry and its hardware work together, and a straight holder on worn or mismatched fasteners will not clamp evenly.

The holder clamps the centre section of the rear blade against the squeegee body. Its job is uniform pressure along the whole length, because a flexible rubber blade only wipes properly if it is held evenly. The centre is also the most demanding place to do that: this is where the water load is highest, so any gap here shows up immediately as a wet line down the middle of the lane.

That makes the holder a common and commonly missed cause of streaking. If it is bent, twisted, or its fastener holes have elongated from years of blade changes, the blade is pinched in some spots and loose in others. Replacing the rubber does not help, and the fault gets blamed on suction.

Inspect it whenever the centre blade is changed, which costs nothing because the part is already out: sight along it for a bend or twist, lay it flat and check for rock, look at the fastener holes for elongation or tearing, and check for corrosion pitting.

When refitting, snug the fasteners evenly from the centre outwards rather than tightening one end down first — that is how a straight holder becomes a bent one.

Compatible Models

This part is shared across 4 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the squeegee drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the rear center blade holder assembly (part# V8307050) do?

It clamps the centre section of the rear squeegee blade against the body with even pressure along its whole length. It is supplied complete with its hardware.

Why does a holder fault show up in the centre first?

Because the centre carries the highest water load — the front blade and the body curve channel the whole width of the machine’s solution inward. Any gap there shows immediately as a wet line down the middle of the lane.

I replaced the rubber and still have a wet line. What now?

Check the holder. Bent, twisted, or with fastener holes elongated by years of blade changes, it pinches the blade in places and leaves it loose in others — and the fault then gets blamed on suction.

How do I order the Rear Center Squeegee Blade Holder Assembly (part# V8307050) or get help?

You can add the Rear Center Squeegee Blade Holder Assembly (part# V8307050) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the rear center squeegee blade holder assembly (part# V8307050) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Rear Center Squeegee Blade Holder Assembly V8307050”

Your email address will not be published. Required fields are marked *