Tornado Screw #8-32 x 1 in. PX73
$2.99
Genuine OEM #8-32 x 1 in. machine screw (part# PX73) for commercial high-speed burnishers — the cover screw listed beside the motor cover on all three Tornado Brute Force burnisher drawings (see full list below).
The PX73 is a #8-32 machine screw, 1 inch long. It appears on every drawing in the Brute Force burnisher book, on the Brute Force 1600 (98458B) and on the Brute Force 2000 (98482B) and on both Brute Force 2000 Dust Control (98486) drawings — in each case listed immediately beside the motor cover (X1458). It is a shared part used across Tornado machines — see the full list of models below.
Small #8-32 screws do the quiet work on a burnisher: they hold covers, switch boxes and light brackets rather than structural joints. That makes them the fasteners most often lost and most often damaged, because they are removed every time anyone gets into the machine for an electrical check and they are small enough to strip with a power driver in a second. A missing cover screw is not cosmetic on a machine with 115V wiring behind the cover — a panel held by two of its three screws vibrates, works loose, and exposes wiring.
Replace the PX73 if the threads are damaged, if the head is chewed up, or if it no longer draws the cover down tight. Tighten it by hand at the end rather than running it home with a driver — #8-32 threads in a moulded or thin-gauge part will strip long before the screw does. If you find a hole that no longer holds, stop and call us rather than fitting a larger screw: enlarging the hole makes the panel unusable, while the correct repair is usually a new insert or a new cover.
Note that the drawings also list a shorter #8-32 x 1/2 inch screw (X8272) and other small hardware, so check the length at the callout before you order. This is shared hardware and carries no model name — call 763-535-0770 with your model and serial number if you want us to confirm which screw belongs where.
Compatible Models
- Tornado models:
Frequently asked questions
Where is the #8-32 x 1 in. screw (part# PX73) used on a Brute Force burnisher?
It appears on the Brute Force 1600 (98458B) drawing and on the Brute Force 2000 (98482B) and both Brute Force 2000 Dust Control (98486) drawings, listed beside the motor cover.
How do I know if my PX73 screw needs replacing?
Replace it if the threads are stripped, the head is rounded from a slipping driver, or it no longer pulls the cover down tight. Never leave a cover held by fewer screws than the drawing shows.
What is the difference between PX73 and X8272?
Both are #8-32 screws, but the PX73 is 1 inch long and the X8272 is 1/2 inch long. Check the callout on your drawing before ordering — the two are easy to confuse on the bench.
What models is the #8-32 x 1 in. screw (part# PX73) compatible with?
All three Tornado Brute Force burnishers: the 1600 (98458B), the 2000 High-Speed Glazer (98482B) and the 2000 Dust Control (98486).
How do I order the #8-32 x 1 in. screw (part# PX73) or get help?
You can add the #8-32 x 1 in. screw (part# PX73) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.






Reviews
There are no reviews yet