Screw M4 x 7 60100411
$1.99
Genuine OEM M4 x 7 mm screw (part# 60100411) for Tornado floor scrubbers. It is the very short M4 used where a component mounts against a shallow boss.
Genuine OEM M4 x 7 mm screw (part# 60100411) for Tornado floor scrubbers — compatible machines are listed below. In the drive wheel control assembly it fastens a component where there is only a shallow thread behind the mounting face.
At 7 mm this is about as short as an M4 gets, and that is deliberate rather than incidental. Control assemblies are built in tight spaces with boards, brackets and wiring packed close together, and behind many of these mounting points there is either a shallow blind boss or something that must not be touched. A longer screw there either bottoms out — so the wrench reads tight while the component is still loose — or presses into a board, a wire or a moving part behind the panel. Neither failure is visible from the front.
M4 is also a size with very little margin. There is barely any thread engaged and very little head to grip, so the drive recess rounds off easily and the host thread usually strips before the screw does. Use the correct driver, tighten to seat rather than to feel, and if the joint will not hold, inspect the thread it goes into before fitting another screw — a stripped boss needs its own repair.
Replace a screw whose drive recess is damaged, whose thread is galled, or whose shank is bent. A bent M4 holds its component crooked, which on a control assembly can mean a switch or board that no longer sits where it should.
Compatible Models
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BDSO 20/21 — TS120-S59-U
This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the drive wheel control drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
Where is the screw (part# 60100411) used?
In the drive wheel control assembly, fastening a component where there is only a shallow thread behind the mounting face.
Why such a short screw?
Because behind many of these mounting points there is a shallow blind boss or something that must not be touched. A longer screw bottoms out — so the wrench reads tight while the component is loose — or presses into a board, a wire or a moving part. Neither is visible from the front.
The joint will not hold. What should I check?
The thread it goes into. At M4 the host boss usually strips before the screw does, and a stripped boss needs its own repair. Also check the screw for a bend, which leaves a switch or board sitting crooked.
How do I order the Screw M4 x 7 (part# 60100411) or get help?
You can add the Screw M4 x 7 (part# 60100411) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the screw m4 x 7 (part# 60100411) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet