Spring 47230120

$34.99

Genuine OEM spring (part# 47230120) for Tornado stand-on floor scrubbers. It is the heavy spring in the squeegee lift linkage that lets the squeegee break away from an obstacle and then pulls it back to its working position.

Genuine OEM spring (part# 47230120) for Tornado stand-on floor scrubbers — see the machine list below. This is the heavy spring in the squeegee lift linkage, mounted at a pivot with its own washer and bushing and held by a through-screw, and it is a far more substantial part than the small tension springs used elsewhere in the same assembly.

It does two things. When the squeegee is lowered, it sets the load that holds the blades against the floor; too little and the blades skate over water, too much and they fold and wear. And when the squeegee hits something it cannot pass — a pallet leg, a dock plate, a floor drain lip — the spring stretches and lets the whole squeegee swing back rather than snapping the arm. Once the obstruction is clear it pulls the squeegee back to its working position.

Because that break-away function only happens occasionally, a failing spring often goes unnoticed until the day the squeegee gets damaged. Symptoms to watch for: the squeegee no longer returns fully to centre after a knock, the machine starts leaving water even with fresh blades, the squeegee visibly bounces or floats over wet patches instead of staying planted, or you can see that the spring coils have pulled apart and no longer sit closed at rest. Rust or a cracked coil is a replace-now condition.

Replace it with the linkage supported and the tension released — never try to lever a loaded spring off its anchor. Check the bushing and washer at the same pivot while the spring is off, because a tired spring lets the joint cycle further than designed and those parts usually wear together. Reassemble so the linkage swings freely, then test on a wet lane and confirm the squeegee drops cleanly and returns to centre.

This is the genuine Tornado spring, matched to the original rate and free length, so the down pressure and the break-away force are back to the values the machine was designed around rather than something close.

Compatible Models

This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the squeegee control drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the spring (part# 47230120) do on a Tornado stand-on scrubber?

It is the heavy spring in the squeegee lift linkage. It sets the load holding the blades against the floor when the squeegee is down, and it lets the squeegee swing back out of the way when it strikes an obstacle, then pulls it home again.

How do I know if the spring (part# 47230120) needs replacing?

Look for a squeegee that does not return fully to centre after being knocked, water left behind even with new blades, a squeegee that bounces or floats over wet patches, or coils that have pulled apart and no longer close at rest. A cracked coil or heavy rust means replace it now.

Can a weak spring here damage other parts?

Yes. A tired spring lets the linkage cycle further than it was designed to, which wears the bushing and washer at the same pivot, and it removes the controlled break-away that protects the squeegee arm from impacts. That is how a cheap spring failure turns into a bent arm.

How do I order the Spring (part# 47230120) or get help?

You can add the Spring (part# 47230120) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the spring (part# 47230120) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Spring 47230120”

Your email address will not be published. Required fields are marked *