Spring Washer X8101

$2.99

Genuine OEM spring washer (part# X8101) for Tornado and Powr-Flite commercial high-speed burnishers — the sprung washer used in the wheel and axle hardware. Fits all Tornado Brute Force burnishers (see full list below).

The X8101 is a spring washer used on the Brute Force burnishers, listed on every drawing in the book, on the Brute Force 1600 (98458B), on the Brute Force 2000 (98482B), and on both Brute Force 2000 Dust Control (98486) drawings — in each case grouped with the wheels, axles and the washers and screws that retain them.

A spring washer is a load-maintaining part, not a spacer. It is formed so that it keeps a defined axial force on the joint as the parts it sits between wear, warm up and settle. In a wheel and axle assembly that is exactly what you want: enough preload that nothing rattles, but enough give that the wheel is not clamped solid against its face.

Replace the X8101 when it has been crushed flat, cracked, or corroded, and as a matter of routine whenever you pull a wheel or axle apart. A flattened spring washer is the usual explanation for a wheel that developed a rattle a week after it was serviced: on the bench the assembly felt right, but the washer had no travel left to take up the first few hours of bedding in. Because these washers are pennies, inspecting them is a waste of time — fit new ones.

If you are rebuilding a wheel station, order the spring washer with the wheel, axle and the retaining hardware shown at the same callouts, and check whether your machine takes the 5 inch (X8024) or 4 inch (X8935) wheel at that position. The washer is shared across the Brute Force burnisher line and carries no model name. Call 763-535-0770 with your model and serial number if you want the wheel hardware set listed. It is a shared part used across Tornado and Powr-Flite machines — see the full list of models below.

Compatible Models

Frequently asked questions

What does the spring washer (part# X8101) do on a burnisher?

It maintains a controlled axial load in the wheel and axle hardware, taking up wear and settling so the assembly stays snug without clamping the wheel solid.

How do I know if my X8101 spring washer needs replacing?

If it has been crushed flat, cracked or corroded it has no spring left. These washers cost pennies, so fit new ones whenever a wheel or axle is taken apart rather than inspecting the old ones.

My wheel rattled again a week after service — why?

Most often a re-used spring washer that had already been flattened. With no travel left it cannot take up the bedding-in that happens in the first few hours after a rebuild.

What models is the spring washer (part# X8101) compatible with?

All three Tornado Brute Force burnishers: the 1600 (98458B), the 2000 High-Speed Glazer (98482B) and the 2000 Dust Control (98486).

How do I order the spring washer (part# X8101) or get help?

You can add the spring washer (part# X8101) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Spring Washer X8101”

Your email address will not be published. Required fields are marked *