Tornado Brute Force 2000 98486 Pulley Cover X1454
$6.99
Genuine OEM pulley cover (part# X1454) for the Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486 — the guard over the belt and pulley drive. Shown on the current main body drawing.
The X1454 pulley cover is the guard that closes off the belt and pulley drive on the Brute Force 2000 Dust Control glazer (Model 98486). It appears on the current 14 July 2025 main body drawing and on the earlier 29 December 2022 main assembly. It is specific to the dust-control machine — the 98458B and 98482B drawings do not list it — which is why this listing names the model.
The cover does two jobs. It keeps fingers and debris out of a belt running between the motor pulley and the main pulley, and on a dust-control machine it also helps keep the drive area closed so airborne finish dust does not pack into the belt and pulley grooves. A loaded pulley groove makes the belt slip, and a slipping belt on a 2,000 RPM burnisher means lost pad speed, a shiny glazed belt and eventually a snapped one.
Replace the X1454 if it is cracked, warped, missing mounting tabs, or no longer sits flush. A cover that rattles against the pulley will wear through, and one that no longer fits properly leaves a gap that both debris and fingers can get into. Never run the machine with the pulley cover removed — a V-belt drive at burnishing speed is an open pinch point.
If you are in the machine for a belt or pulley job, check the cover while you have it off: cracks usually start at the fastener holes where the cover is pulled down tight. Call 763-535-0770 with your model and serial number if you need help identifying the cover for your vintage of 98486 — the machine is covered by two dated drawings and the callout number differs between them. It is a shared part used across Tornado machines — see the full list of models below.
Compatible Models
- Tornado models:
Frequently asked questions
What does the pulley cover (part# X1454) do on the Tornado 98486?
It guards the belt and pulley drive, keeping fingers and debris out and helping keep finish dust from packing into the belt and pulley grooves.
How do I know if my X1454 pulley cover needs replacing?
Replace it if it is cracked (usually starting at the fastener holes), warped, missing a mounting tab, rattling against the pulley, or no longer sitting flush.
Can I run the burnisher without the pulley cover?
No. A V-belt drive turning at burnishing speed is an open pinch point, and an uncovered drive also lets finish dust pack into the pulley grooves and make the belt slip.
What models is the pulley cover (part# X1454) compatible with?
The Tornado Brute Force 2000 High-Speed Glazer with Dust Control, Model 98486, on both its current 14 July 2025 and earlier 29 December 2022 drawings.
How do I order the pulley cover (part# X1454) or get help?
You can add the pulley cover (part# X1454) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.






Reviews
There are no reviews yet