Tornado BDSO 27/28 Battery Cable with SB80 Connector 49815201
$98.99
Genuine OEM battery cable with SB80 connector (part# 49815201) for Tornado floor scrubbers. It is the main battery lead, terminated and ready to fit.
Genuine OEM battery cable with SB80 connector (part# 49815201), red-marked, for Tornado floor scrubbers — compatible machines are listed below. It is a main battery lead supplied complete with its terminal and its SB80 connector housing.
Main battery cables are the highest-current path on the machine, and they are not a place to improvise. Conductor size is matched to the current, the terminals are crimped with the right tool to a gas-tight joint, and the connector is a type rated for repeated connection under load. A hand-made substitute that is a size down, or carries a poorly crimped lug, runs hot — and a hot connection is a fire risk in a compartment that can contain hydrogen while charging.
The symptom of a bad main cable is usually performance rather than failure: voltage drops across a resistive joint under load, so the machine feels weak, runtime falls, and the controller may cut out on low voltage while the battery itself is fine. A joint that has been running hot often shows discoloured insulation near the terminal, and the terminal or connector face may be pitted or blackened.
Check connections before replacing anything: terminals clean and tight, no corrosion creep under the insulation, and the connector faces bright rather than burnt.
When fitting, observe polarity, disconnect the pack before working, and keep tools away from bridging terminals. Tighten terminals properly — an under-torqued high-current joint is exactly the resistive connection this part exists to avoid.
Compatible Models
See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the battery cable (part# 49815201) do?
It is a main battery lead, supplied complete with its terminal and SB80 connector housing — the highest-current path on the machine.
My machine feels weak and the runtime has dropped, but the batteries test fine. Why?
Often a resistive main cable joint. Voltage drops across it under load, so the machine feels weak and the controller may cut out on low voltage while the pack itself is healthy. Look for discoloured insulation near a terminal and pitted or blackened connector faces.
Can I make up my own battery cable?
Better not to. Conductor size is matched to the current and the terminals need a proper gas-tight crimp. An undersized cable or a poor crimp runs hot, and a hot connection is a fire risk in a compartment that can contain hydrogen while charging.
How do I order the Battery Cable with SB80 Connector (part# 49815201) or get help?
You can add the Battery Cable with SB80 Connector (part# 49815201) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the battery cable with sb80 connector (part# 49815201) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet