Tornado BDSO 27/28 Front Squeegee Blade Holder 48315010

$60.99

Genuine OEM front squeegee blade holder (part# 48315010) for the Tornado BDSO 27/28. It is the strip that clamps the front blade to the squeegee body.

Genuine OEM front squeegee blade holder (part# 48315010) for the Tornado BDSO 27/28 stand-on scrubber. It is the strip that clamps the front rubber against the squeegee body, holding it straight, evenly, and at the right projection below the frame.

Evenly is the operative word. A blade is a flexible strip of rubber, and it only wipes properly if it is held with uniform pressure along its whole length. The holder is what provides that. If it is bent, twisted, or has elongated fastener holes, the blade is pinched in some places and loose in others, and it lifts off the floor at the loose spots. The operator then replaces rubber that is not worn out, sees no improvement, and starts suspecting the vacuum.

Holders get damaged in predictable ways. They are at floor level at the front of the squeegee, so they take impacts from debris, thresholds and dock plates; they are removed and refitted at every blade change, which wears their fastener holes; and they corrode over years in constant moisture, which makes them weak and sometimes brittle.

Inspect it at every blade change — it costs nothing, the part is already in your hands. Sight along it for a bend or twist, check the fastener holes for elongation or tearing, and look for corrosion pitting along its length. Lay it on a flat surface: it should sit flat with no rock.

Fit it with the fasteners snugged evenly from the centre outwards rather than tightening one end down first, which is how a straight holder gets bent.

Compatible Models

See where this part sits on the machine on the squeegee drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the front blade holder (part# 48315010) do?

It clamps the front squeegee rubber against the body with uniform pressure along its whole length, holding the blade straight and at the right projection below the frame.

New rubber did not fix my streaking. Could it be the holder?

Yes. A bent, twisted or hole-worn holder pinches the blade in places and leaves it loose in others, so the rubber lifts off the floor at the loose spots regardless of how new it is.

How do I check a blade holder?

At every blade change, while it is already in your hands: sight along it for a bend or twist, check the fastener holes for elongation, look for corrosion pitting, and lay it on a flat surface to see whether it rocks.

How do I order the Front Squeegee Blade Holder (part# 48315010) or get help?

You can add the Front Squeegee Blade Holder (part# 48315010) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the front squeegee blade holder (part# 48315010) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Tornado BDSO 27/28 Front Squeegee Blade Holder 48315010”

Your email address will not be published. Required fields are marked *