Tornado BDSO 27/28 Hose 10 x 160 47630440

$3.99

Genuine OEM 10 mm x 160 mm hose (part# 47630440) for Tornado floor scrubbers. It is the smaller-bore short solution line in the water valve assembly.

Genuine OEM hose (part# 47630440), 10 mm bore by 160 mm long, for Tornado floor scrubbers — the machines it fits are listed below. It is the smaller-bore short section in the water valve assembly. A 14 mm hose of the same length is used elsewhere in the same assembly; they are not interchangeable, so order by part number.

That difference is the whole point. The solution circuit is balanced around the restriction of every section in it, and bore is the dominant factor — flow through a pipe falls away steeply as the bore is reduced. Fitting a 10 mm section where a 14 mm belongs starves whatever is downstream, and the machine quietly lays down less water than it should at every control setting with nothing visibly wrong.

Length matters as well. A hose that is too long kinks where there is no space for the slack, and a kink is a restriction nobody can see; one that is too short pulls constantly on both fittings and eventually cracks one of them at the thread root.

Failures are the familiar ones for solution hose: hardening with age and chemical exposure until the ends no longer seal on their barbs, a permanent groove where a clamp was over-tightened, and hairline splits at bends or behind clamps that weep only under flow. Because this is a pressurised-but-low-head circuit, a weep draws air in as readily as it pushes water out, which gives flow that varies run to run.

Replace rather than patch, and fit new clamps tightened only enough to seal.

Compatible Models

See where this part sits on the machine on the water valve drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the hose (part# 47630440) do?

It is the smaller-bore short solution line section in the water valve assembly. A 14 mm hose of the same length is used elsewhere in the same assembly.

Can I use the 14 mm hose instead?

No. Flow through a pipe falls away steeply as bore is reduced, so the circuit is balanced around the sizes designed in. The wrong bore starves whatever is downstream and the machine quietly lays down less water at every setting.

Why do hose faults here show as inconsistent flow rather than a leak?

Because this is a low-head circuit — a weep draws air into the line as readily as it pushes water out. Air gives flow that varies run to run and will not respond predictably to the control.

How do I order the Hose 10 x 160 (part# 47630440) or get help?

You can add the Hose 10 x 160 (part# 47630440) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the hose 10 x 160 (part# 47630440) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Tornado BDSO 27/28 Hose 10 x 160 47630440”

Your email address will not be published. Required fields are marked *