Tornado BDSO 27/28 Squeegee Actuator Wiring Harness 49815026

$26.99

Genuine OEM squeegee actuator wiring harness (part# 49815026) for Tornado floor scrubbers. It is the pre-made loom connecting the squeegee lift actuator to the machine’s electrics.

Genuine OEM squeegee actuator wiring harness (part# 49815026) for Tornado floor scrubbers — the machines it fits are listed below. It carries power and signals between the squeegee lift actuator and the machine’s control electrics, pre-terminated with the correct connectors at each end.

Of the two actuator harnesses on this machine, the squeegee one has the harder life. It runs to the very back of the machine, into the wettest zone there is — recovery water is being dragged along the floor right beneath it — and it has to flex every time the squeegee is raised and lowered, which happens many times an hour on a route machine. Flex plus moisture is what finishes wiring.

So the failures are characteristic. A conductor can break inside its insulation at the flex point, which looks perfect from outside and gives an intermittent that follows squeegee movement. Water tracks into a connector and corrodes the terminals, giving a fault that appears after a wash-down and clears as things dry. And the outer sheath chafes wherever the loom passes a frame edge, especially if a clip has been left off at a previous service.

Diagnose before replacing: unplug both ends and inspect the terminals, then operate the squeegee lift while flexing the loom. A fault that comes and goes as the harness moves locates itself.

Fit the new harness along the original route and refit every clip — an unclipped loom at the back of a scrubber chafes through in months, and a repair splice in that environment will not last.

Compatible Models

See where this part sits on the machine on the electrical layout drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the squeegee actuator wiring harness (part# 49815026) do?

It carries power and signals between the squeegee lift actuator and the machine’s control electrics, made to length with the correct connectors at each end.

Why does this harness fail more than others?

Because it runs to the back of the machine — the wettest zone, with recovery water being dragged along the floor beneath it — and it flexes every time the squeegee is raised and lowered, many times an hour. Flex plus moisture is what finishes wiring.

How do I find the fault?

Unplug both ends and inspect the terminals for corrosion, then operate the squeegee lift while flexing the loom along its length. A conductor broken inside its insulation looks perfect from outside but shows up as an intermittent that follows the movement.

How do I order the Squeegee Actuator Wiring Harness (part# 49815026) or get help?

You can add the Squeegee Actuator Wiring Harness (part# 49815026) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the squeegee actuator wiring harness (part# 49815026) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Tornado BDSO 27/28 Squeegee Actuator Wiring Harness 49815026”

Your email address will not be published. Required fields are marked *