Trigger Roll Pin X8918

$1.99

Genuine OEM roll pin (part# X8918) for Tornado and Powr-Flite commercial high-speed burnishers — the spring pin the trigger handle pivots on, supplied inside the X8911-K handle assembly and separately here.

The X8918 is the roll pin that the trigger handle pivots on. It appears on the Brute Force 1600 (98458B) drawing, and inside the complete handle assembly (X8911-K) on the Brute Force 2000 (98482B) and the 29 December 2022 Brute Force 2000 Dust Control (98486) drawings.

A roll pin — also called a spring pin — is a rolled strip of spring steel that compresses slightly as it is driven in, so it grips its bore without needing a head, a nut or a circlip. That makes it ideal for a pivot in a moulded part: it stays put under vibration and it can be driven out and replaced with a punch when the trigger is serviced.

Replace the X8918 if the pin has worn down where the trigger pivots on it, if it has started to walk out of its bore, if it is distorted or corroded, and always when you fit a new trigger handle. The sign of a worn pin is a trigger that rocks or feels sloppy even though the trigger itself looks fine. A pin that has walked partly out is worth attending to before it comes out entirely, because a trigger that loses its pivot in use leaves the operator without a control.

Always fit a new roll pin rather than re-using the old one: a spring pin loses radial tension once it has been driven out, so a re-used pin will not grip its bore properly and will start walking again. Drive it in squarely with a pin punch and support the moulding from behind. The part is available individually rather than only inside the complete handle assembly. Call 763-535-0770 with your model and serial number if you want it listed for your handle build. It is a shared part used across Tornado and Powr-Flite machines — see the full list of models below.

Compatible Models

Frequently asked questions

What does the roll pin (part# X8918) do on a burnisher?

It is the spring pin the trigger handle pivots on. Being a rolled spring-steel pin, it grips its bore without a head or retaining clip.

How do I know if my X8918 roll pin needs replacing?

Replace it if the pin has worn where the trigger pivots, if it has started to walk out of its bore, or if it is distorted or corroded. A trigger that rocks or feels sloppy with a sound trigger handle points to the pin.

Can I re-use a roll pin after driving it out?

No. A spring pin loses radial tension once it has been removed, so a re-used pin will not grip and will start walking out again. Always fit a new one.

What models is the roll pin (part# X8918) compatible with?

The Tornado Brute Force 1600 (98458B), the Brute Force 2000 High-Speed Glazer (98482B) and the Brute Force 2000 Dust Control (98486) as built to its 29 December 2022 drawing.

How do I order the roll pin (part# X8918) or get help?

You can add the roll pin (part# X8918) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 can help you find the right part for your machine.

Reviews

There are no reviews yet

Be the first to review “Trigger Roll Pin X8918”

Your email address will not be published. Required fields are marked *