Vacuum Motor 49320160

$547.99

Genuine OEM vacuum motor (part# 49320160) for Tornado floor scrubbers. It is the motor that creates the suction pulling dirty water off the floor through the squeegee and into the recovery tank — the single most important component in the recovery circuit.

Genuine OEM vacuum motor (part# 49320160) for Tornado floor scrubbers — the machines it fits are listed below. This is the motor that makes the recovery side of the machine work: it pulls air through the squeegee, up the suction hose and into the recovery tank, taking the dirty water with it and leaving a dry floor behind the machine.

It is mounted on its own base and support, isolated by a vibration damper, sealed to the tank by a gasket, and protected from carry-over water by the separator above it. Every one of those parts exists to keep this motor alive, which tells you how the machine is designed: the motor is the expensive component and everything around it is sacrificial.

Symptoms of a failing vacuum motor are usually gradual. Suction drops off even though the squeegee blades are good, the tank seals are sound and the float is clean. The motor note changes — higher pitched, or rougher. It runs hot enough to smell. Brush dust appears under the motor housing. At the end, it either seizes, trips the circuit, or spins without moving meaningful air because the fan stack has failed. Before condemning it, always check the obvious causes of lost suction first: a dirty or clogged separator, a stuck float shut-off, a cracked lid gasket, a blocked hose, or worn squeegee blades.

Carbon brushes are a serviceable item on this motor and are available separately. A motor that has lost suction and is drawing brush dust may need brushes rather than a complete replacement, which is a far cheaper repair — worth checking before ordering a motor. If the armature or the bearings are gone, however, brushes will not save it.

When fitting a new motor, replace the gasket and inspect the vibration damper and separator at the same time. A new motor bolted down onto a hardened gasket or a collapsed damper will leak air, run hot and fail early — the three parts work as a set.

Compatible Models

  • Tornado BD 26/26 — 99726
  • Tornado BD 28/20 — 99728
  • Tornado TS550-W28-U — 99729
  • Tornado BD 32/26 — 99732
  • Tornado BD 26/27 — 99770
  • Tornado BD 26/27 — 99772
  • Tornado BR 28/27 — 99775
  • Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
  • Tornado BDSO 20/21 — TS120-S59-U
  • Tornado 99729 — TS550-W28-U

This part is shared across 10 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.

See where this part sits on the machine on the vacuum drawing, or browse every Tornado BDSO 27/28 parts diagram.

Frequently Asked Questions

What does the vacuum motor (part# 49320160) do on a Tornado floor scrubber?

It creates the suction that pulls dirty water off the floor through the squeegee and the suction hose into the recovery tank. It is the component that makes the machine leave a dry floor rather than a wet one.

How do I know if the vacuum motor (part# 49320160) needs replacing?

Look for suction that has dropped with good blades, sound seals and a clean float; a changed motor note; a hot or burning smell; or carbon dust under the housing. Rule out a clogged separator, a stuck float, a cracked lid gasket, a blocked hose and worn blades first — those cause the same symptom far more often.

Can I replace the carbon brushes instead of the whole motor?

Often, yes. Carbon brushes are a serviceable item on this motor and are available separately, so a motor losing suction and shedding brush dust may only need brushes. If the bearings or armature have failed, brushes will not save it.

How do I order the Vacuum Motor (part# 49320160) or get help?

You can add the Vacuum Motor (part# 49320160) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.

Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the vacuum motor (part# 49320160) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.

Reviews

There are no reviews yet

Be the first to review “Vacuum Motor 49320160”

Your email address will not be published. Required fields are marked *