Washer 60303006
$1.99
Genuine OEM washer (part# 60303006) for Tornado floor scrubbers. It spreads fastener load at control assembly mountings.
Genuine OEM washer (part# 60303006) for Tornado floor scrubbers — compatible machines are listed below. In the drive wheel control assembly it goes under the head or nut of a fastener at a component mounting.
The job is to spread the clamping load over a wider bearing area and give the fastener a flat, smooth face to turn against. On a control assembly, both halves of that matter for a specific reason: much of what these fasteners bear against is a circuit board, a plastic housing or thin sheet. Without a washer, the small area under a screw head digs in — into a board it can crack the laminate or lift a track, into plastic it creeps and the joint loses its clamp within weeks, and into thin sheet it leaves a dent that costs the tension.
There is an electrical dimension too. On some mountings the fastener and its washer form part of the ground path for a board or a bracket. A washer that is corroded, or one left out so the contact area is tiny, gives a high-resistance ground — which produces intermittent faults that look like a failing board and are not.
Washers are also the component most often left out of a reassembly. Count them back in.
Replace one that is dished, cracked, burred around the bore, or corroded enough to have lost its flat face. Dishing means it has yielded and now contacts only at its rim, losing the bearing area it was fitted for.
Compatible Models
- Tornado BDSO 27/28 Stand-On Scrubber — 99786 / 99786C
- Tornado BDSO 20/21 — TS120-S59-U
This part is shared across 2 Tornado machines. If your machine is not listed, call 763-535-0770 and we will check it for you.
See where this part sits on the machine on the drive wheel control drawing, or browse every Tornado BDSO 27/28 parts diagram.
Frequently Asked Questions
What does the washer (part# 60303006) do?
It spreads the fastener’s clamping load over a wider area and gives the head or nut a flat face to turn against — which matters because these fasteners often bear against a circuit board, plastic housing or thin sheet.
Can a missing washer cause an electrical fault?
It can. On some mountings the fastener and washer are part of a board or bracket’s ground path, and a tiny or corroded contact area gives a high-resistance ground — producing intermittent faults that look like a failing board.
When should it be replaced?
When it is dished, cracked, burred around the bore, or corroded enough to have lost its flat face. A dished washer contacts only at its rim and has lost the bearing area it was fitted for.
How do I order the Washer (part# 60303006) or get help?
You can add the Washer (part# 60303006) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.
Manufacturer specifications for the Tornado BDSO 27/28 stand-on scrubber are published by Tornado Industries at tornadovac.com. If you are not certain the washer (part# 60303006) is the right part for your machine, call Twin City Vacuum at 763-535-0770 or stop in at 5415 West Broadway, Crystal, MN 55428 — we have been servicing commercial floor equipment since 1956.






Reviews
There are no reviews yet