Bearing X9001

The Bearing (part# X9001) is a genuine Tacony OEM replacement part from the brush assembly of the Tornado Marathon SE 900 self-contained carpet extractor. It is the bearing that supports the brushroll and lets it turn freely under load.

What the Bearing does

The bearing takes the weight of the brushroll plus everything the machine pushes into the carpet through it, and it has to do that in a wet, gritty environment for thousands of hours. Load is rarely what finishes it. What finishes it is fibre wrapping the shaft and drawing solution and grit past the shield, so a bearing that fails early is usually reporting a maintenance gap rather than a defect.

When to replace the Bearing (X9001)

Replace it when the brush is noisy, rough or notchy when spun by hand, when there is play at the shaft, or when the brush drags and loads the drive. A bearing that has begun to run hot or has visible corrosion should be changed before it seizes and takes the axle with it.

Bearing X9001 — fitment and installation notes

Fit the new bearing square and to full depth rather than tapping one side, and check the shaft and housing for wear while you are in, since a new bearing in a worn housing will be loose from the start. Clear all wrapped fibre from the shaft and refit the bearing shield properly, because leaving that out is how the new bearing ends up as short-lived as the old one. Tacony builds the Tornado Marathon SE 900 and the Powr-Flite Prowler PFX900S on a single machine platform, so this component carries across both brands rather than belonging to either one. It is a shared Tacony component and may fit additional models beyond those listed — call us and we will confirm against your serial number.

Compatible Models for the Bearing

• Tornado Marathon SE 900 — Model 98170
• Powr-Flite Prowler PFX900S
• Powr-Flite PFX900SG

Twin City Vacuum has been selling and servicing commercial floor-care equipment since 1956 from 5415 West Broadway, Crystal, MN 55428. We stock genuine Tacony parts and ship nationwide. Browse the full Tornado 98170 parts catalogue, or see the manufacturer at tornadovac.com.

Frequently Asked Questions

What does the Bearing do on the Tornado Marathon SE 900?

The bearing takes the weight of the brushroll plus everything the machine pushes into the carpet through it, and it has to do that in a wet, gritty environment for thousands of hours. Load is rarely what finishes it. What finishes it is fibre wrapping the shaft and drawing solution and grit past the shield, so a bearing that fails early is usually reporting a maintenance gap rather than a defect.

How do I know if my Bearing needs replacing?

Replace it when the brush is noisy, rough or notchy when spun by hand, when there is play at the shaft, or when the brush drags and loads the drive. A bearing that has begun to run hot or has visible corrosion should be changed before it seizes and takes the axle with it.

What models is the Bearing (part# X9001) compatible with?

The Tornado Marathon SE 900 (Model 98170), the Powr-Flite Prowler PFX900S and the PFX900SG. It is a shared Tacony part and may fit further models; call us to confirm.

How do I order the Bearing (part# X9001) or get help?

You can add the Bearing (part# X9001) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.