Powr-Flite PFX900S Steel Solenoid Bracket X2543

The Powr-Flite PFX900S solenoid bracket X2543 is the genuine OEM steel bracket that carries the solution solenoid valve on the Powr-Flite Prowler PFX 900S-T 9-gallon self-contained carpet extractor. It is one of the two parts the later chassis drawing adds, and it is specific to this machine.

What the solenoid bracket X2543 does

The solution side of a self-contained extractor runs from the pump through a solenoid valve that opens when the trigger is pulled, and that valve has to be held rigidly. The X2543 bracket bolts to the chassis and gives the valve a flat steel seat, so the brass fittings on either side are only carrying solution pressure, not the mass of the valve bouncing on its plumbing. On a machine that is pushed, dropped off kerbs and run with a brush motor vibrating underneath it, that matters: an unsupported valve works its threaded joints loose and starts weeping at the fittings long before anything actually fails.

When to replace the solenoid bracket X2543

Replace it if the bracket is bent, if a mounting hole has elongated or cracked, or if corrosion has eaten into the steel. The usual symptom is a valve that no longer sits square, or a solution leak that reappears a week after the fittings were tightened. A bracket that has already been straightened once tends to fatigue in the same spot, so it is worth replacing rather than bending back.

Compatible Models for the solenoid bracket X2543

• Powr-Flite Prowler PFX 900S-T — Model PFX900S, chassis assembly with bracket, from serial 0926007288

This is a single-model part. Its factory Where-Used record lists the PFX900S and nothing else, and it does not appear on the earlier 7 August 2023 chassis sheet. Twin City Vacuum has been selling and servicing Powr-Flite commercial floor equipment since 1956. Read more about the machine at powr-flite.com.

Frequently Asked Questions

What does the solenoid bracket X2543 do on the Powr-Flite PFX 900S-T?

It is the steel bracket that mounts the 120 VAC solution solenoid valve to the chassis of the 9-gallon self-contained extractor. It holds the valve square and steady so the brass fittings either side of it are not carrying the weight of the valve, and so vibration from the brush motor does not work the plumbing loose.

How do I know if the solenoid bracket X2543 needs replacing?

Replace it if it is bent, cracked at a mounting hole, or rusted through, or if the valve will no longer sit square against it. A bracket that has been bent back into shape once usually fatigues at the same place. If the valve is shifting under the hose pull, check the bracket before you blame the fittings.

What models is the solenoid bracket X2543 (part# X2543) compatible with?

It is used on the Powr-Flite Prowler PFX 900S-T, Model PFX900S, and on no other machine. It appears at callout 53 on the chassis-with-bracket drawing, which covers machines built from serial number 0926007288 onward; the earlier 7 August 2023 chassis sheet does not carry it.

How do I order the solenoid bracket X2543 (part# X2543) or get help?

You can add the solenoid bracket (part# X2543) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Powr-Flite equipment since 1956 and can help confirm the right part for your machine.

Questions? Call us at 763-535-0770 or visit us at 5415 West Broadway, Crystal, MN 55428.