Cord Clamp X9111

The Cord Clamp (part# X9111) is a genuine Tacony OEM replacement part from the recovery and solution tank assembly of the Tornado Marathon SE 900 self-contained carpet extractor. It is the clamp that secures the power cord to the machine along its route.

What the Cord Clamp does

Cord management on a wet machine is a safety item rather than tidiness. A clamped cord stays out of the wand path, off the wet floor, and away from anything hot or moving, and it means a snag pulls against the clamp instead of dragging the cord through whatever it is lying against. Cords that fail early almost always fail where they were left free to rub.

When to replace the Cord Clamp (X9111)

Replace it when the clamp is cracked, when it no longer grips and the cord slides through, or when its mounting has pulled out. A shiny worn band on the cord jacket at the clamp means the clamp has been loose long enough to be sanding the jacket.

Cord Clamp X9111 — fitment and installation notes

Clamp on the jacket and never tighten hard enough to flatten the cord, since crushing the jacket deforms the insulation underneath. Keep the routing the machine was built with rather than inventing a shorter path, and inspect the cord at each clamp whenever the machine is serviced. Tacony builds the Tornado Marathon SE 900 and the Powr-Flite Prowler PFX900S on a single machine platform, so this component carries across both brands rather than belonging to either one. It is a shared Tacony component and may fit additional models beyond those listed — call us and we will confirm against your serial number.

Compatible Models for the Cord Clamp

• Tornado Marathon SE 900 — Model 98170
• Powr-Flite Prowler PFX900S
• Powr-Flite PFX900SG

Twin City Vacuum has been selling and servicing commercial floor-care equipment since 1956 from 5415 West Broadway, Crystal, MN 55428. We stock genuine Tacony parts and ship nationwide. Browse the full Tornado 98170 parts catalogue, or see the manufacturer at tornadovac.com.

Frequently Asked Questions

What does the Cord Clamp do on the Tornado Marathon SE 900?

Cord management on a wet machine is a safety item rather than tidiness. A clamped cord stays out of the wand path, off the wet floor, and away from anything hot or moving, and it means a snag pulls against the clamp instead of dragging the cord through whatever it is lying against. Cords that fail early almost always fail where they were left free to rub.

How do I know if my Cord Clamp needs replacing?

Replace it when the clamp is cracked, when it no longer grips and the cord slides through, or when its mounting has pulled out. A shiny worn band on the cord jacket at the clamp means the clamp has been loose long enough to be sanding the jacket.

What models is the Cord Clamp (part# X9111) compatible with?

The Tornado Marathon SE 900 (Model 98170), the Powr-Flite Prowler PFX900S and the PFX900SG. It is a shared Tacony part and may fit further models; call us to confirm.

How do I order the Cord Clamp (part# X9111) or get help?

You can add the Cord Clamp (part# X9111) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.