E Ring X9114

The E Ring (part# X9114) is a genuine Tacony OEM replacement part from the brush assembly of the Tornado Marathon SE 900 self-contained carpet extractor. It is the E-shaped retaining ring that snaps into a shaft groove to stop a component moving along the shaft.

What the E Ring does

An E ring holds by springing into a machined groove, so it resists axial movement without needing a thread, a nut or any tool but a screwdriver blade. That makes it the right answer on a pivot or pin that has to be taken apart occasionally, and it also means the ring is only as good as its spring. Once it has been sprung too wide it will sit in the groove looking correct and let go under load.

When to replace the E Ring (X9114)

Replace it whenever it has been removed, and immediately if it is distorted, opened out, or cracked at an arm. A component that has developed end float on its shaft, or an E ring found loose in the machine, both mean a new ring goes in and the groove gets inspected.

E Ring X9114 — fitment and installation notes

Fit it fully into the groove rather than partly seated, and keep a hand or a rag over it during fitting because these fly a long way when they slip. Check the groove for wear or damage while the ring is off, and never straighten and reuse one that has been sprung. Tacony builds the Tornado Marathon SE 900 and the Powr-Flite Prowler PFX900S on a single machine platform, so this component carries across both brands rather than belonging to either one. It is a shared Tacony component and may fit additional models beyond those listed — call us and we will confirm against your serial number.

Compatible Models for the E Ring

• Tornado Marathon SE 900 — Model 98170
• Powr-Flite Prowler PFX900S
• Powr-Flite PFX900SG

Twin City Vacuum has been selling and servicing commercial floor-care equipment since 1956 from 5415 West Broadway, Crystal, MN 55428. We stock genuine Tacony parts and ship nationwide. Browse the full Tornado 98170 parts catalogue, or see the manufacturer at tornadovac.com.

Frequently Asked Questions

What does the E Ring do on the Tornado Marathon SE 900?

An E ring holds by springing into a machined groove, so it resists axial movement without needing a thread, a nut or any tool but a screwdriver blade. That makes it the right answer on a pivot or pin that has to be taken apart occasionally, and it also means the ring is only as good as its spring. Once it has been sprung too wide it will sit in the groove looking correct and let go under load.

How do I know if my E Ring needs replacing?

Replace it whenever it has been removed, and immediately if it is distorted, opened out, or cracked at an arm. A component that has developed end float on its shaft, or an E ring found loose in the machine, both mean a new ring goes in and the groove gets inspected.

What models is the E Ring (part# X9114) compatible with?

The Tornado Marathon SE 900 (Model 98170), the Powr-Flite Prowler PFX900S and the PFX900SG. It is a shared Tacony part and may fit further models; call us to confirm.

How do I order the E Ring (part# X9114) or get help?

You can add the E Ring (part# X9114) directly to your cart on this page, or call us at 763-535-0770. Our staff at 5415 West Broadway, Crystal, MN 55428 has been servicing Tornado equipment since 1956 and can help confirm the right part for your machine.